Serial: 8250/16550 driver, 3 ports, IRQ sharing disabled serial8250.0: ttyS0 at MMIO 0x1c42000 (irq = 25) is a 16550A serial8250.0: ttyS1 at MMIO 0x1d0c000 (irq = 53) is a 16550A console [ttyS1] enabled serial8250.0: ttyS2 at MMIO 0x1d0d000 (irq = 61) is a 16550A brd: module loaded at24 1-0050: 256 byte 24c02 EEPROM, read-only, 0 bytes/write MityOMAPL138: Found MAC = 00:50:c2:bf:8d:b3 MityOMAPL138: Part Number = 1810-DG-225-RC ahci ahci: forcing PORTS_IMPL to 0x1 ahci ahci: AHCI 0001.0100 32 slots 1 ports 3 Gbps 0x1 impl platform mode ahci ahci: flags: ncq sntf pm led clo only pmp pio slum part ccc scsi0 : ahci_platform ata1: SATA max UDMA/133 mmio [mem 0x01e18000-0x01e19fff] port 0x100 irq 67 NAND device: Manufacturer ID: 0x2c, Chip ID: 0xca (Micron NAND 256MiB 3,3V 16-bit) Bad block table found at page 131008, version 0x01 Bad block table found at page 130944, version 0x01 Creating 2 MTD partitions on "davinci_nand.1": 0x000000000000-0x000008000000 : "rootfs" 0x000008000000-0x000010000000 : "homefs" davinci_nand davinci_nand.1: controller rev. 2.5 spi_davinci spi_davinci.1: DMA: supported spi_davinci spi_davinci.1: DMA: RX channel: 18, TX channel: 19, event queue: 0 m25p80 spi1.0: m25p64-nonjedec (8192 Kbytes) Creating 8 MTD partitions on "m25p80": 0x000000000000-0x000000010000 : "ubl" 0x000000010000-0x000000090000 : "u-boot" 0x000000090000-0x0000000a0000 : "u-boot-env" 0x0000000a0000-0x0000000b0000 : "periph-config" No LCD configured MII PHY configured 0x0000000b0000-0x000000100000 : "reserved" 0x000000100000-0x000000400000 : "kernel" 0x000000400000-0x000000600000 : "fpga" 0x000000600000-0x000000800000 : "spare" spi_davinci spi_davinci.1: Controller at 0xfef0e000 CAN device driver interface mcp251x spi1.1: probed davinci_mdio davinci_mdio.0: davinci mdio revision 1.5 davinci_mdio davinci_mdio.0: detected phy mask fffffff7 davinci_mdio.0: probed davinci_mdio davinci_mdio.0: phy[3]: device 0:03, driver unknown ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver ohci ohci.0: DA8xx OHCI ohci ohci.0: new USB bus registered, assigned bus number 1 Waiting for USB PHY clock good... ohci ohci.0: irq 59, io mem 0x01e25000 ata1: SATA link down (SStatus 0 SControl 300) hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected Initializing USB Mass Storage driver... usbcore: registered new interface driver usb-storage USB Mass Storage support registered. mousedev: PS/2 mouse device common for all mice omap_rtc omap_rtc: rtc core: registered omap_rtc as rtc0 omap_rtc: RTC power up reset detected omap_rtc: already running i2c /dev entries driver cpuidle: using governor ladder cpuidle: using governor menu davinci_mmc davinci_mmc.0: Using DMA, 4-bit mode usbcore: registered new interface driver usbhid usbhid: USB HID core driver dsd1791 spi1.2: Failed to add route LLOUT->Line Out asoc: dsd1791 <-> davinci-mcasp.0 mapping ok ALSA device list: #0: MityDSP-L138 INDIO TCP cubic registered NET: Registered protocol family 17 can: controller area network core (rev 20090105 abi 8) NET: Registered protocol family 29 can: raw protocol (rev 20090105) regulator_init_complete: LDO2: incomplete constraints, leaving on regulator_init_complete: LDO1: incomplete constraints, leaving on regulator_init_complete: VDCDC3: incomplete constraints, leaving on regulator_init_complete: VDCDC2: incomplete constraints, leaving on regulator_init_complete: VDCDC1: incomplete constraints, leaving on console [netcon0] enabled netconsole: network logging started omap_rtc omap_rtc: setting system clock to 2000-01-01 00:30:27 UTC (946686627) List of all partitions: 1f00 131072 mtdblock0 (driver?) 1f01 131072 mtdblock1 (driver?) 1f02 64 mtdblock2 (driver?) 1f03 512 mtdblock3 (driver?) 1f04 64 mtdblock4 (driver?) 1f05 64 mtdblock5 (driver?) 1f06 320 mtdblock6 (driver?) 1f07 3072 mtdblock7 (driver?) 1f08 2048 mtdblock8 (driver?) 1f09 2048 mtdblock9 (driver?) No filesystem could mount root, tried: ext3 ext2 cramfs vfat msdos Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(31,0) [] (unwind_backtrace+0x0/0xe0) from [] (panic+0x58/0x188) [] (panic+0x58/0x188) from [] (mount_block_root+0x1bc/0x1fc) [] (mount_block_root+0x1bc/0x1fc) from [] (mount_root+0xa0/0xc0) [] (mount_root+0xa0/0xc0) from [] (prepare_namespace+0x15c/0x1bc) [] (prepare_namespace+0x15c/0x1bc) from [] (kernel_init+0xe8/0x11c) [] (kernel_init+0xe8/0x11c) from [] (kernel_thread_exit+0x0/0x8)