 
U-Boot SPL 2013.10-g6c6a700 (Nov 20 2013 - 16:56:02)
MityARM335x profile 1 - Model No: 3359-GX-226-RC Serial No: 123765
Old factory config found, configuring for 256 MB DDR2
Configuring for 256 MB DDR2 @ 266MHz
Critical Link AM335X Dev Kit -- NAND Page size = 2048k booting from dev 8
reading u-boot.img
reading u-boot.img


U-Boot 2013.10-g6c6a700 (Nov 20 2013 - 16:56:02)

AM335X-GP rev 0
I2C:   ready
DRAM:  256 MiB
WARNING: Caches not enabled
NAND:  Using 2k bch8 layout
ECC Mode = 2 lo = 56/0
256 MiB
MMC:   OMAP SD/MMC: 0, OMAP SD/MMC: 1
*** Warning - bad CRC, using default environment

Net:   cpsw:1 is connected to cpsw.  Reconnecting to cpsw
cpsw
Hit any key to stop autoboot:  1  0 
SD/MMC found on device 0
reading uenv.txt
2162 bytes read in 5 ms (421.9 KiB/s)
Loaded environment from uenv.txt
Importing environment from mmc ...
reading uImage
3639976 bytes read in 416 ms (8.3 MiB/s)
## Booting kernel from Legacy Image at 80007fc0 ...
   Image Name:   Linux-3.1.0+
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    3639912 Bytes = 3.5 MiB
   Load Address: 80008000
   Entry Point:  80008000
   Verifying Checksum ... OK
   XIP Kernel Image ... OK

Starting kernel ...

Uncompressing Linux... done, booting the kernel.
 