Linux version 2.6.34-rc1 (zoltan@zoltandev) (gcc version 4.5.1 (Sourcery G++ Lit e 2010.09-50) ) #4 PREEMPT Wed Jun 29 15:56:42 CDT 2011 CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=00053177 CPU: VIVT data cache, VIVT instruction cache Machine: MityDSP-L138 Peripheral Config Block Found Enet_Config = 2 PHYMask = 0x8 No LCD Configured UART[0] = 0, 0, 0, 115200 UART[1] = 1, 1, 0, 115200 UART[2] = 0, 0, 0, 115200 SPI[0] = 0, 0, 00, 0, 0 SPI[1] = 1, 1, 01, 0, 30000000 Memory policy: ECC disabled, Data cache writethrough On node 0 totalpages: 12288 free_area_init_node: node 0, pgdat c035a41c, node_mem_map c0386000 DMA zone: 96 pages used for memmap DMA zone: 0 pages reserved DMA zone: 12192 pages, LIFO batch:1 DaVinci da850/omap-l138 variant 0x0 Built 1 zonelists in Zone order, mobility grouping on. Total pages: 12192 Kernel command line: mem=48M console=ttyS1,115200n8 root=/dev/ram0 rw initrd=0xc 1180000,16M PID hash table entries: 256 (order: -2, 1024 bytes) Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) Memory: 48MB = 48MB total Memory: 28724k/28724k available, 20428k reserved, 0K highmem Virtual kernel memory layout: vector : 0xffff0000 - 0xffff1000 ( 4 kB) fixmap : 0xfff00000 - 0xfffe0000 ( 896 kB) DMA : 0xff000000 - 0xffe00000 ( 14 MB) vmalloc : 0xc3800000 - 0xfea00000 ( 946 MB) lowmem : 0xc0000000 - 0xc3000000 ( 48 MB) modules : 0xbf000000 - 0xc0000000 ( 16 MB) .init : 0xc0008000 - 0xc0025000 ( 116 kB) .text : 0xc0025000 - 0xc0320000 (3052 kB) .data : 0xc0338000 - 0xc035ae40 ( 140 kB) Experimental preemptable hierarchical RCU implementation. NR_IRQS:373 Console: colour dummy device 80x30 Calibrating delay loop... 149.50 BogoMIPS (lpj=747520) Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok DaVinci: gpio irqs disabled on bank 6 DaVinci: 144 gpio irqs regulator: core version 0.5 NET: Registered protocol family 16 mityomapl138_init... mityomapl138_setup_nand: using 16 bit data EMAC: MII PHY configured, RMII PHY will not be functional mityomapl138_init: setting phy_mask to 8 bio: create slab at 0 SCSI subsystem initialized usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb regulator: VDCDC1: 1150 <--> 1350 mV at 1200 mV regulator: VDCDC2: 1710 <--> 1910 mV at 3300 mV regulator: VDCDC3: 1120 <--> 1320 mV at 1800 mV regulator: LDO1: 1800 mV regulator: LDO2: 3300 mV Switching to clocksource timer0_1 NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 2048 (order: 2, 16384 bytes) TCP bind hash table entries: 2048 (order: 1, 8192 bytes) TCP: Hash tables configured (established 2048 bind 2048) TCP reno registered UDP hash table entries: 256 (order: 0, 4096 bytes) UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) NET: Registered protocol family 1 RPC: Registered udp transport module. RPC: Registered tcp transport module. RPC: Registered tcp NFSv4.1 backchannel transport module. Trying to unpack rootfs image as initramfs... rootfs image is not initramfs (no cpio magic); looks like an initrd Freeing initrd memory: 16384K JFFS2 version 2.2. (NAND) © 2001-2006 Red Hat, Inc. msgmni has been set to 88 io scheduler noop registered (default) Serial: 8250/16550 driver, 3 ports, IRQ sharing disabled serial8250.0: ttyS0 at MMIO 0x1c42000 (irq = 25) is a 16550A serial8250.0: ttyS1 at MMIO 0x1d0c000 (irq = 53) is a 16550A console [ttyS1] enabled serial8250.0: ttyS2 at MMIO 0x1d0d000 (irq = 61) is a 16550A brd: module loaded at24 1-0050: 256 byte 24c02 EEPROM (read-only) MityOMAPL138: Found MAC = 00:50:c2:bf:89:05 MityOMAPL138: Part Number = L138-CG-225-RC MityOMAPL138: setting max frequency to 300 MHz NAND device: Manufacturer ID: 0x2c, Chip ID: 0xca (Micron NAND 256MiB 3,3V 16-bi t) Bad block table found at page 131008, version 0x01 Bad block table found at page 130944, version 0x01 nand_bbt: ECC error while reading bad block table nand_read_bbt: Bad block at 0x000009100000 Creating 2 MTD partitions on "davinci_nand.1": 0x000000000000-0x000008000000 : "rootfs" 0x000008000000-0x000010000000 : "homefs" davinci_nand davinci_nand.1: controller rev. 2.5 spi_davinci spi_davinci.1: DMA: supported spi_davinci spi_davinci.1: DMA: RX channel: 18, TX channel: 19, event queue: 0 spi_davinci spi_davinci.1: registered master spi1 spi spi1.0: setup mode 0, 8 bits/w, 30000000 Hz max --> 0 m25p80 spi1.0: m25p64 (8192 Kbytes) Creating 8 MTD partitions on "m25p80": 0x000000000000-0x000000010000 : "ubl" 0x000000010000-0x000000090000 : "u-boot" 0x000000090000-0x0000000a0000 : "u-boot-env" 0x0000000a0000-0x0000000b0000 : "periph-config" 0x0000000b0000-0x000000100000 : "reserved" 0x000000100000-0x000000400000 : "kernel" 0x000000400000-0x000000600000 : "fpga" 0x000000600000-0x000000800000 : "spare" spi_davinci spi_davinci.1: registered child spi1.0 spi_davinci spi_davinci.1: Controller at 0xfef0e000 console [netcon0] enabled netconsole: network logging started ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver ohci ohci.0: DA8xx OHCI ohci ohci.0: new USB bus registered, assigned bus number 1 Waiting for USB PHY clock good... ohci ohci.0: irq 59, io mem 0x01e25000 hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected omap_rtc omap_rtc: rtc core: registered omap_rtc as rtc0 omap_rtc: RTC power up reset detected omap_rtc: already running i2c /dev entries driver cpuidle: using governor ladder cpuidle: using governor menu TCP cubic registered NET: Registered protocol family 17 Clocks: disable unused i2c1 Clocks: disable unused emac Clocks: disable unused mcasp Clocks: disable unused lcdc Clocks: disable unused mmcsd Clocks: disable unused spi0 Clocks: disable unused mcbsp0 Clocks: disable unused mcbsp1 Clocks: disable unused vpif Clocks: disable unused ecap Clocks: disable unused ehrpwm regulator_init_complete: incomplete constraints, leaving LDO2 on regulator_init_complete: incomplete constraints, leaving LDO1 on regulator_init_complete: incomplete constraints, leaving VDCDC3 on regulator_init_complete: incomplete constraints, leaving VDCDC2 on regulator_init_complete: incomplete constraints, leaving VDCDC1 on emac-mii: probed omap_rtc omap_rtc: setting system clock to 2000-01-06 01:06:30 UTC (947120790) RAMDISK: gzip image found at block 0 VFS: Mounted root (ext2 filesystem) on device 1:0. Freeing init memory: 116K eth0: attached PHY driver [Generic PHY] (mii_bus:phy_addr=1:03, id=40005201) PHY: 1:03 - Link is Up - 100/Full