Booting Linux on physical CPU 0x0 Linux version 3.14.8+ (jcormier@jcormier-fedora) (gcc version 4.5.4 20120305 (prerelease) (GCC) ) #23 PREEMPT Tue Jun 24 10:52:06 EDT 2014 CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=00053177 CPU: VIVT data cache, VIVT instruction cache Machine: MityDSP-L138/MityARM-1808 Ignoring unrecognised tag 0x42000101 Memory policy: Data cache writethrough DaVinci da850/omap-l138/am18x variant 0x1 Built 1 zonelists in Zone order, mobility grouping on. Total pages: 24384 Kernel command line: mem=96M console=ttyS1,115200n8 mtdparts=nand:128M(rootfs),-(userfs) root=/dev/mtdblock0 rw,noatime rootfstype=jffs2 PID hash table entries: 512 (order: -1, 2048 bytes) Dentry cache hash table entries: 16384 (order: 4, 65536 bytes) Inode-cache hash table entries: 8192 (order: 3, 32768 bytes) Memory: 91776K/98304K available (3759K kernel code, 229K rwdata, 1280K rodata, 153K init, 157K bss, 6528K reserved) Virtual kernel memory layout: vector : 0xffff0000 - 0xffff1000 ( 4 kB) fixmap : 0xfff00000 - 0xfffe0000 ( 896 kB) vmalloc : 0xc6800000 - 0xff000000 ( 904 MB) lowmem : 0xc0000000 - 0xc6000000 ( 96 MB) modules : 0xbf000000 - 0xc0000000 ( 16 MB) .text : 0xc0008000 - 0xc04f4018 (5041 kB) .init : 0xc04f5000 - 0xc051b6bc ( 154 kB) .data : 0xc051c000 - 0xc05554c0 ( 230 kB) .bss : 0xc05554cc - 0xc057cb1c ( 158 kB) SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 Preemptible hierarchical RCU implementation. NR_IRQS:245 sched_clock: 32 bits at 24MHz, resolution 41ns, wraps every 178956969942ns Console: colour dummy device 80x30 Calibrating delay loop... 148.88 BogoMIPS (lpj=744448) pid_max: default: 32768 minimum: 301 Mount-cache hash table entries: 1024 (order: 0, 4096 bytes) Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes) CPU: Testing write buffer coherency: ok Setting up static identity map for 0xc0390378 - 0xc03903d0 devtmpfs: initialized pinctrl core: initialized pinctrl subsystem regulator-dummy: no parameters NET: Registered protocol family 16 DMA: preallocated 256 KiB pool for atomic coherent allocations cpuidle: using governor ladder cpuidle: using governor menu baseboard_pre_init: Entered mityomapl138_setup_nand: using 8 bit data #### spi len: 3 baseboard_init [IndustrialIO]... bio: create slab at 0 SCSI subsystem initialized usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb VDCDC1: 1150 <--> 1350 mV at 1200 mV VDCDC2: 3300 mV VDCDC3: 1800 mV LDO1: 1800 mV LDO2: 2500 <--> 3300 mV at 3300 mV Advanced Linux Sound Architecture Driver Initialized. Switched to clocksource timer0_1 NET: Registered protocol family 2 TCP established hash table entries: 1024 (order: 0, 4096 bytes) TCP bind hash table entries: 1024 (order: 0, 4096 bytes) TCP: Hash tables configured (established 1024 bind 1024) TCP: reno registered UDP hash table entries: 256 (order: 0, 4096 bytes) UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) NET: Registered protocol family 1 RPC: Registered named UNIX socket transport module. RPC: Registered udp transport module. RPC: Registered tcp transport module. RPC: Registered tcp NFSv4.1 backchannel transport module. futex hash table entries: 256 (order: -1, 3072 bytes) jffs2: version 2.2. (NAND) © 2001-2006 Red Hat, Inc. msgmni has been set to 179 io scheduler noop registered (default) Serial: 8250/16550 driver, 3 ports, IRQ sharing disabled serial8250.0: ttyS0 at MMIO 0x1c42000 (irq = 25, base_baud = 9375000) is a 16550A serial8250.1: ttyS1 at MMIO 0x1d0c000 (irq = 53, base_baud = 9375000) is a 16550A console [ttyS1] enabled serial8250.2: ttyS2 at MMIO 0x1d0d000 (irq = 61, base_baud = 9375000) is a 16550A brd: module loaded at24 1-0050: 256 byte 24c02 EEPROM, read-only, 0 bytes/write MityOMAPL138: Found MAC = 00:50:c2:e6:70:b5 MityOMAPL138: Part Number = L138-DG-225-RI ahci ahci: forcing PORTS_IMPL to 0x1 ahci ahci: AHCI 0001.0100 32 slots 1 ports 3 Gbps 0x1 impl platform mode ahci ahci: flags: ncq sntf pm led clo only pmp pio slum part ccc scsi0 : ahci_platform ata1: SATA max UDMA/133 mmio [mem 0x01e18000-0x01e19fff] port 0x100 irq 67 nand: device found, Manufacturer ID: 0x2c, Chip ID: 0xda nand: Micron MT29F2G08ABAEAWP nand: 256MiB, SLC, page size: 2048, OOB size: 64 Bad block table found at page 131008, version 0x01 Bad block table found at page 130944, version 0x01 Creating 2 MTD partitions on "davinci_nand.1": 0x000000000000-0x000008000000 : "rootfs" mityomapl138_notify_add: Entered - mtd->name rootfs 0x000008000000-0x000010000000 : "homefs" mityomapl138_notify_add: Entered - mtd->name homefs davinci_nand davinci_nand.1: controller rev. 2.5 spi_davinci spi_davinci.1: request RX DMA channel failed CAN device driver interface ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver ohci ohci.0: DA8xx OHCI ohci ohci.0: new USB bus registered, assigned bus number 1 Waiting for USB PHY clock good... ohci ohci.0: irq 59, io mem 0x01e25000 usb usb1: New USB device found, idVendor=1d6b, idProduct=0001 usb usb1: New USB device strings: Mfr=3, Product=2, SerialNumber=1 usb usb1: Product: DA8xx OHCI usb usb1: Manufacturer: Linux 3.14.8+ ohci_hcd usb usb1: SerialNumber: ohci.0 hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected usbcore: registered new interface driver usb-storage mousedev: PS/2 mouse device common for all mice omap_rtc da830-rtc: rtc core: registered da830-rtc as rtc0 da830-rtc: RTC power up reset detected da830-rtc: already running i2c /dev entries driver davinci_mmc da830-mmc.0: Can't get dma_tx channel davinci_mmc da830-mmc.0: Using PIO, 4-bit mode usbcore: registered new interface driver usbhid usbhid: USB HID core driver soc-audio soc-audio.0: ASoC: machine MityDSP-L138 INDIO should use snd_soc_register_card() soc-audio soc-audio.0: ASoC: CODEC spi1.2 not registered ata1: SATA link down (SStatus 0 SControl 300) platform soc-audio.0: Driver soc-audio requests probe deferral TCP: cubic registered NET: Registered protocol family 17 can: controller area network core (rev 20120528 abi 9) NET: Registered protocol family 29 can: raw protocol (rev 20120528) mmc0: new high speed SDHC card at address 1234 mmcblk0: mmc0:1234 SA04G 3.67 GiB mmcblk0: p1 LDO2: incomplete constraints, leaving on LDO1: incomplete constraints, leaving on VDCDC3: incomplete constraints, leaving on VDCDC2: incomplete constraints, leaving on VDCDC1: incomplete constraints, leaving on regulator-dummy: incomplete constraints, leaving on soc-audio: probe of soc-audio.0 failed with error -22 console [netcon0] enabled netconsole: network logging started omap_rtc da830-rtc: setting system clock to 2000-01-06 18:49:07 UTC (947184547) ALSA device list: No soundcards found. jffs2: Empty flash at 0x050e8af4 ends at 0x050e9000 jffs2: Empty flash at 0x074c7018 ends at 0x074c7800 jffs2: Empty flash at 0x074c9100 ends at 0x074c9800 jffs2: Empty flash at 0x07bcd108 ends at 0x07bcd800 VFS: Mounted root (jffs2 filesystem) on device 31:0. devtmpfs: mounted Freeing unused kernel memory: 152K (c04f5000 - c051b000)