Activity
From 02/09/2018 to 03/10/2018
03/09/2018
- 02:00 PM Software Development: RE: Linux Boot Parameter and NAND Partition
- You can manually update the nand partition tables by changing the file arch/arm/mach-davinci/board-mityomapl138.c and...
- 05:20 AM Software Development: RE: Linux Boot Parameter and NAND Partition
- > Where did you print out this partition table?
From the @mtdparts@ command of the U-Boot. It is also consistent w...
03/08/2018
- 02:41 PM Software Development: RE: Linux Boot Parameter and NAND Partition
- Okan Çalış wrote:
> Hi,
>
> I have a general question about Linux on MityDsp, which might help me solve "the prob... - Hi,
I have a general question about Linux on MityDsp, which might help me solve "the problem I consulted you about...
02/22/2018
- 03:12 PM Software Development: RE: Kernel panics on custom board: "No init found. Try passing init= option to kernel"
- Okan Çalış wrote:
> Hi Jonathan, thanks for your reply.
>
> > The kernel and u-boot both have to use the same ECC... - 12:07 PM Software Development: RE: Kernel panics on custom board: "No init found. Try passing init= option to kernel"
- Hi Jonathan, thanks for your reply.
> The kernel and u-boot both have to use the same ECC strength.
I'm afraid ...
02/21/2018
- 02:14 PM Software Development: RE: Kernel panics on custom board: "No init found. Try passing init= option to kernel"
- Okan Çalış wrote:
> Hi,
>
> I couldn't reply sooner because I've been handling some other kernel-related problems... - 07:38 AM Software Development: RE: Kernel panics on custom board: "No init found. Try passing init= option to kernel"
- Hi,
I couldn't reply sooner because I've been handling some other kernel-related problems by using NFS as a tempor...
02/13/2018
- I have an Industrial I/O board and need to get the AUDIO_SYSCLK signal out to an expansion board connector. Currently...
Also available in: Atom
Go to top
