Project

General

Profile

Activity

From 11/16/2018 to 12/15/2018

11/28/2018

07:36 AM Software Development: RE: Double boot u-Boot
Thank Jonathan,
The problem is resolved. The problem was in hardware.
Oleh Mela

11/21/2018

02:35 PM Software Development: RE: Double boot u-Boot
Oleh Mela wrote:
> Jonathan,
> Could be my problem connected with to the that there is no pull-up on SPI1 on the ow...
Jonathan Cormier
11:08 AM Software Development: RE: Double boot u-Boot
Jonathan,
Could be my problem connected with to the that there is no pull-up on SPI1 on the own carrier board?
Th...
Oleh Mela

11/19/2018

07:44 PM Software Development: RE: Double boot u-Boot
That is very strange. Could you comment out pieces of your code until it starts working again? To see if you can de... Jonathan Cormier
03:17 PM Software Development: RE: Double boot u-Boot
Jonathan,
with simple hello world dsp program following is:
OMAP-L138/AM-1808/AM-1810 initialization passed!
Con...
Oleh Mela
03:13 PM Software Development: RE: Double boot u-Boot
U-Boot > printenv
bootargs=mem=96M console=ttyS1,115200n8 root=/dev/mtdblock0 rw rootwait
bootdelay=3
baudrate=115...
Oleh Mela
02:35 PM Software Development: RE: Double boot u-Boot
Oleh,
Could you provide your u-boot environment? @printenv@
Does this processor reset happen when the DSP prog...
Jonathan Cormier
11:38 AM Software Development: Double boot u-Boot
Hi,
I run myfile.out on the MityDSP-L138 (L138-DX-225-RI) module (not MityDSP-L138F). Linux not use (according to ...
Oleh Mela
 

Also available in: Atom

Go to top
Add picture from clipboard (Maximum size: 1 GB)