Activity
From 11/15/2019 to 12/14/2019
11/21/2019
- MG 06:52 AM Software Development: RE: NAND Flash
- OK, I will try with TI's Processor SDK.
Thank you for your time.
Best regards
11/20/2019
- BD 03:36 PM Software Development: RE: NAND Flash
- Marcin,
If you are using a Critical Link product in your design we are happy to help in this forum. From your comments, it looks like you are not using a Critical Link product. Our U-Boot is customized for our specific SOM. I would no... - MG 06:35 AM Software Development: RE: NAND Flash
This is not SOM. But our module, similar to the MityDSP-L138 only with one memory (NAND) and we use the U-Boot 2009.11.
I am looking for information about what may be the cause of wrong ECC calculation. Can I path this u-boot or use...
11/19/2019
- JC 03:47 PM Software Development: RE: NAND Flash
- Could you provide all the information on the barcode located on the module? Serial number, model number, etc.
It looks like you have a custom version of the UBL and u-boot.
Some oddities are that your clocks are non standard. U-b... - MG 06:30 AM Software Development: RE: NAND Flash
- Boot log
11/18/2019
- JC 03:04 PM Software Development: RE: NAND Flash
- Please attach a complete boot log. And the output of 'printenv'
- Hello,
I have a board based on MityDSP-L138 with 4 Gb NAND Flash (MT29F4G08ABADAWP). And I use MityDSP-L138 u-boot (U-Boot 2009.11). But I probably have problem with ECC calculation. After some time during booting I get message: