Mity CPU Platforms » MitySOM-QC6490

03/24/2026

03:46 PM Software Development: RE: Long build times

That matches what I'm seeing, although it seems your machine is much faster than mine. For me it's about 7 hours for ... Nathan Olson

02:36 AM Software Development: RE: Long build times

Hi Nathan,
We have similar experiences. Unfortunately we do not currently have a fix. We are building off of Qual... Gregory Gluszek

02:42 AM Software Development: RE: Configuring the QUP pins

Hi Nathan,
Please refer to the [[Configuring the QUP Ports (I2C I3C SPI and UART)]] wiki page which has recently ... Gregory Gluszek

03/21/2026

12:06 AM Software Development: Configuring the QUP pins

Hello,
My carrier board uses several QUP pins for I2C, UART, and SPI. How do I configure them? I prefer a device-t... Nathan Olson

03/20/2026

06:14 PM Software Development: Long build times

Hello,
I am extending the BSP with my own layer. It seems like whenever I make a change, a lot of unrelated files ... Nathan Olson

02/24/2026

09:39 PM PCB Development: RE: Auto start

When talking about input power to the SOM that would be the 3V7-BAT rail.
There would be a delay between power bei... William Evans

09:14 PM PCB Development: RE: Auto start

Thanks!
Does power have to be high for a certain amount of time before the power-on pulse? If so, which rail and f... Nathan Olson

07:30 PM PCB Development: RE: Auto start

The only "automatic" power on we have implemented so far is software control from an Arduino.
There are two main s... William Evans

03:15 PM PCB Development: Auto start

I'm using DC power and I'd like to auto-start the SOM when power is applied. What are the requirements for the signal... Nathan Olson