Mity CPU Platforms » MityDSP-L138 (ARM9 Based Platforms)

06/02/2011

12:17 PM Software Development: RE: ECC

Ok, Thanks for the quick response. Rob Gillis

12:11 PM Software Development: RE: ECC

We are using mobile DDR2 x16 for our modules. There is no support for ECC.
-Mike
Michael Williamson

11:56 AM Software Development: ECC

Hello,
Does the MityDSP L138 module support ECC for the DDR2 RAM? If so, is there software support to enable this... Rob Gillis

05/27/2011

10:00 AM FPGA Development: RE: FPGA configuration

Rob,
The INIT_B pin (connected with external pullup to OMAP pin D2, AXR7/EPWMITZ[0]/GP1[15]) is an open drain outp... Michael Williamson

09:37 AM FPGA Development: RE: FPGA configuration

Mike, I figured that readback may be an issue, but thanks for confirming it for me. Does the INIT pin provide proof ... Rob Gillis

05/26/2011

08:50 PM FPGA Development: RE: FPGA configuration

Hi Rob,
Right now, we don't have an easy way to verify configuration cooked up.
The current MityDSP-L138F famil... Michael Williamson

05:32 PM FPGA Development: FPGA configuration

Hello,
I'm trying to figure out an approach for validating the bitfile has been programmed correctly, and for moni... Rob Gillis

05/18/2011

10:46 AM Software Development: RE: uPP support

Hi Brian,
For the OMAP-L138, pin-muxing is just a fact of life. If you would like to use ethernet and uPP, then i... Michael Williamson

09:32 AM Software Development: RE: uPP support

Hi Mike
This sounds good. An additional question would be about the pin configuration for the uPP port. In the exc... Brian Rasmussen

08:02 AM Software Development: RE: Can't extract release 2011-03

Hi Mike
Thanks for your quick reply. I will try it out.
BR
Brian Brian Rasmussen

07:53 AM Software Development: RE: Can't extract release 2011-03

Hi Brian,
The .run file is really just a shell script. Turns out that it is calling out "/bin/sh" to run the scri... Michael Williamson

03:07 AM Software Development: Can't extract release 2011-03

Hi
I'm not able to extract the latest board support package release.
I have downloaded the "release_2011-03-31.... Brian Rasmussen

05/17/2011

10:53 AM Software Development: RE: uPP support

Brian,
You should not have a problem achieving the rates you mentioned above. We have accomplished similar throug... Michael Williamson

10:44 AM Software Development: RE: uPP support

Hi Mike
We have discussed about the uPP port, and we have decided to try and use it in our project, due to the nic... Brian Rasmussen

05/06/2011

09:52 AM Software Development: RE: uPP support

Hi Mike
You can send me the code by email.
I have downloaded the latest BSP, but haven't had the time to look a... Brian Rasmussen

05/05/2011

10:04 AM Software Development: RE: uPP support

Hi Brian,
Unfortunately, there is no linux side UPP driver available from TI. We have written one (it's rough) an... Michael Williamson

09:56 AM Software Development: uPP support

Hi
In the datasheet for the MityDSP L138 board there is a schematic with "uPP" interface between the OMAP and the ... Brian Rasmussen