Mity CPU Platforms » MityDSP-L138 (ARM9 Based Platforms)

04/26/2012

12:21 AM Software Development: RE: FS Corruption due to dropping power

Hi Mike,
Thanks for the reply. This is reasuring that it is a FS corruption problem. I have instigated a read onl... Keith Fletcher

04/25/2012

12:57 PM Software Development: RE: Starterware EMIFA to FPGA example code

Hi Emmett,
Are you using linux or starterware? On starterware, if you are launching from u-Boot (which configures... Michael Williamson

12:37 PM Software Development: Starterware EMIFA to FPGA example code

Hello,
I have used your "EMIFA_iface" VHDL example to make a simple FPGA to test by reading/writing to registers r... Emmett Bradford

04/13/2012

06:31 PM PCB Development: RE: RTC Battery Drain

Hi,
Wanted to follow up on this. We have seen RTC battery drainage, but at the time we looked at it we were using... Michael Williamson

06:28 PM Software Development: RE: FS Corruption due to dropping power

Hi Keith,
I have seen these symptoms before, and I'm pretty sure it's filesystem corruption related (I suspect ude... Michael Williamson

04/12/2012

04:29 PM Software Development: FS Corruption due to dropping power

Hi, We are developing a system where the user is unlikely to power down gracefully, even if asked to do so and ultima... Keith Fletcher

04/07/2012

09:46 PM PCB Development: RE: SODIMM Pin 53 ...

SPI1_SCS0 is indeed connected to that pin on the module. It is also connected to the chip-select on the on-board SPI... Michael Williamson

09:33 PM PCB Development: SODIMM Pin 53 ...

(Posted on behalf of a customer)
The datasheet for the MITYDSP-L138F shows Pin 53 as reserved, however the Industr... Thomas Catalino

04/06/2012

07:40 AM Software Development: RE: StarterWare question ...

Quick note. The new u-Boot command to load up the Starterware image was "bootelf" not "loadelf". I've corrected the... Michael Williamson

04/05/2012

02:56 AM Software Development: RE: StarterWare question ...

see [[StarterWare]] Stéphane Peter

04/04/2012

02:33 PM Software Development: RE: StarterWare question ...

Hi guys,
Just wanted to give you a heads up that we've been able to get the EVM UART echo example in the TI startw... Michael Williamson

03/30/2012

09:19 AM Software Development: RE: Dead board

All clear.
Today, I received a second Base Board - And with this new hardware, the CPU Board runs normally. --> So, ... Stéphane Peter

06:11 AM Software Development: RE: Write UART2 RS-485 API

Hi Mike:
Thanks for your response. It is working with the 2.6.34-rc1.
It is good timing to assert/de-assert TXE.
... Joe Hung

03/28/2012

11:15 AM Software Development: RE: Dead board

Hi Mike,
Thank you for your hints.
The good news first: Using the gel files (which is extended with the 150MHz ... Stéphane Peter

09:32 AM Software Development: RE: Dead board

Well.
The Address 0xFFFD5684 is ARM local ROM code, so it's not surprising that you can't set a breakpoint at that... Michael Williamson