Mity CPU Platforms » MityDSP-L138 (ARM9 Based Platforms)

03/26/2018

01:56 PM Software Development: RE: Launching Linux Application on Startup

You also want to figure out where this poll is happening in your code or perhaps a driver you've included. And what ... Jonathan Cormier

01:52 PM Software Development: RE: Launching Linux Application on Startup

> poll([{fd=4,
You need to look higher up in the strace log to find out which file is opened as fd (file descriptor)... Jonathan Cormier

03/25/2018

12:05 PM Software Development: RE: Launching Linux Application on Startup

Hi, Jonathan,
I did what you suggested.
The application seems to fail at startup because of a @poll@ call.
*St... Okan Çalış

03/23/2018

01:34 PM Software Development: RE: Launching Linux Application on Startup

Note that you can filter the strace output to reduce the amount of data you get. https://stackoverflow.com/a/30034030 Jonathan Cormier

01:28 PM Software Development: RE: Launching Linux Application on Startup

Okan Çalış wrote:
> > > +[[Linux Startup Process - Systemd]]+
> > > I tried this method; however, it didn't do anyt... Jonathan Cormier

08:39 AM Software Development: RE: Launching Linux Application on Startup

I also tried switching @Type@ to @idle@ to ensure the service is not invoked before all other jobs are completed, but... Okan Çalış

08:18 AM Software Development: RE: Launching Linux Application on Startup

> > +[[Linux Startup Process - Systemd]]+
> > I tried this method; however, it didn't do anything beside printing "@... Okan Çalış

03/21/2018

02:00 PM Software Development: RE: Launching Linux Application on Startup

Okan Çalış wrote:
> Hi,
> I want to adjust the ARM so that it starts an application automatically after startup (or... Jonathan Cormier

12:31 PM Software Development: Launching Linux Application on Startup

Hi,
I want to adjust the ARM so that it starts an application automatically after startup (or login). There seems to... Okan Çalış

12:09 PM Software Development: RE: Kernel panics on custom board: "No init found. Try passing init= option to kernel"

Hi,
I solved this problem by writing the JFFS2 image to the NAND partition via the MTD Utilities in Linux, instead... Okan Çalış

12:08 PM Software Development: RE: Linux Boot Parameter and NAND Partition

Hi,
I solved this problem by writing the JFFS2 image to the NAND partition via the MTD Utilities in Linux, instead... Okan Çalış