Project

General

Profile

Networking requires ifup

Added by Joe Bauman almost 11 years ago

Starting a new post for this question.

When the MityDSP (L138F) boots up, I am unable to connect via SSH. I have to login through the serial port and run "ifup eth0" first - then everything works just fine.

Occurs using static (bootargs ip=192.168.0.110) or dhcp (bootargs ip=dhcp) and the /etc/network/interfaces adjusted accordingly.

xxxx
auto eth0
iface eth0 inet static
address 192.168.0.110
netmask 255.255.255.0
network 192.168.0.0
gateway 192.168.0.1
xxxx

Strangely, it seems to work fine on our office network (not sure exactly how it is set up), but doesn't work on my home network (through wrt54gl router and optional netgear 5 port switch). Is there something in my simple home network that I am missing?

In response to Jonathan's suggestion, networking is linked in rcS, rc0, and rc6.

Thanks much,

Joe.


Replies (4)

RE: Networking requires ifup - Added by Jonathan Cormier almost 11 years ago

Joe,

Looking at the networking startup script, all it does is run ifup -a to bring the interfaces up. Could you try running this command instead or "ifup eth0" and see if the command works? Also watch the kernel messages during boot to see if any errors jump out at you.

-Jonathan

RE: Networking requires ifup - Added by Joe Bauman almost 11 years ago

The only thing in the boot log that jumps out at me is:

davinci_mdio davinci_mdio.0: phy[3]: device 0:03, driver unknown

"ifup -a" seems to work just fine when I run it after the system finishing booting.

root@mityomapl138:~# ifup -a
davinci_mdio davinci_mdio.0: resetting idled controller
net eth0: attached PHY driver [Generic PHY] (mii_bus:phy_addr=0:03, id=40005201)
ADDRCONF(NETDEV_UP): eth0: link is not ready
root@mityomapl138:~# PHY: 0:03 - Link is Up - 100/Full
ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready

The "resetting idled controller" seems to indicate that something has happened to the controller state, but I don't know if that's a normal response.

Joe.

RE: Networking requires ifup - Added by Jonathan Cormier almost 11 years ago

The big difference between your boot and mine is:
I have

rw,rootwait ip=dhcp

and you have
rw,rootwait,ip=192.168.0.110

RE: Networking requires ifup - Added by Joe Bauman almost 11 years ago

Bingo. Good catch. I didn't look close enough at the comma/space separators.

Thanks for your help!

Joe.

    (1-4/4)
    Go to top
    Add picture from clipboard (Maximum size: 1 GB)