Project

General

Profile

Hardware Reset

Added by Craig Little over 11 years ago

Hi There,

Is there a pin on the MityDSP-L138F processor board FPGA which is attached to a
dedicated power-on/hardware reset source which can be used to initialise/reset registers?

Kind regards,
Steven Bremner.


Replies (3)

RE: Hardware Reset - Added by Michael Williamson over 11 years ago

When there is a power on reset, the FPGA will be re-initialized (the program pin is pulled low) and will require reprogramming.

Are you looking for an additional pin that may be used to reset just the FPGA?

-Mike

RE: Hardware Reset - Added by Craig Little over 11 years ago

Hi Mike,

In effect yes. I was wondering if the device/circuit which drives the reset pin of the OMAP processor is also
connected to the FPGA and if yes, which pin.

Regards,
Steven.

RE: Hardware Reset - Added by Michael Williamson over 11 years ago

On the MityDSP-L138F, RESET_IN pin is fed into a TPS3808G33DBVR reset monitor circuit. It is not connected to the FPGA or the OMAP-L138 directly. The output RESET of the TPS3808 is fed to the RESET pin on the OMAP-L138. The OMAP-L138 RESETOUT# signal (ball T17) is connected via a transistor (Q1 on clip of the schematic below) to the PROGRAM pin on the FPGA.

    (1-3/3)
    Go to top
    Add picture from clipboard (Maximum size: 1 GB)