There is no eth0 device in 40-000065-4 release firmware
Added by Anton Bakulev about 8 years ago
Hello,
I've installed a 40-000065-4 release firmware from [[https://support.criticallink.com/redmine/projects/mityvision/wiki/MityCAM-B1910_Firmware]] (by the way, file name is MityCAM_B1910-40-000064-4_soc_camera.img.zip, not a MityCAM_B1910-40-000065-4_soc_camera.img.zip) and got a message about eth0 device error while booting:
EXT3-fs (mmcblk0p2): using internal journal Starting Bootlog daemon: bootlogd. Configuring network interfaces... eth0: ERROR while getting interface flags: No such device SIOCADDRT: Network is unreachable Starting rpcbind daemon...NET: Registered protocol family 10 IPv6: ADDRCONF(NETDEV_UP): usb0: link is not ready done. net.ipv4.conf.default.rp_filter = 1 net.ipv4.conf.all.rp_filter = 1
in 40-000065-2 release firmware there was no such a problem:
EXT3-fs (mmcblk0p2): using internal journal Starting Bootlog daemon: bootlogd. Populating dev cache Configuring network interfaces... eth0: device MAC address 00:50:c2:11:22:33 udhcpc (v1.21.1) started Sending discover... libphy: stmmac-0:03 - Link is Up - 1000/Full Sending discover... Sending discover... No lease, failing SIOCADDRT: Network is unreachable Starting rpcbind daemon...NET: Registered protocol family 10 IPv6: ADDRCONF(NETDEV_UP): usb0: link is not ready done. net.ipv4.conf.default.rp_filter = 1 net.ipv4.conf.all.rp_filter = 1
Please, write how could I fix it?
Replies (2)
RE: There is no eth0 device in 40-000065-4 release firmware - Added by Jeffrey Myers about 8 years ago
Anton,
I sent you an email with instructions on reconfiguring the camera.
RE: There is no eth0 device in 40-000065-4 release firmware - Added by Anton Bakulev about 8 years ago
Jeffrey,
Thank you. Yes, this instructions fixes the problem. Now my MityCam works well by eth0.
