Project

General

Profile

There is no eth0 device in 40-000065-4 release firmware

Added by Anton Bakulev over 7 years ago

Hello,

I've installed a 40-000065-4 release firmware from [[https://support.criticallink.com/redmine/projects/mityvision/wiki/MityCAM-B1910_Firmware]] (by the way, file name is MityCAM_B1910-40-000064-4_soc_camera.img.zip, not a MityCAM_B1910-40-000065-4_soc_camera.img.zip) and got a message about eth0 device error while booting:

EXT3-fs (mmcblk0p2): using internal journal
Starting Bootlog daemon: bootlogd.
Configuring network interfaces... eth0: ERROR while getting interface flags: No such device
SIOCADDRT: Network is unreachable
Starting rpcbind daemon...NET: Registered protocol family 10
IPv6: ADDRCONF(NETDEV_UP): usb0: link is not ready
done.
net.ipv4.conf.default.rp_filter = 1
net.ipv4.conf.all.rp_filter = 1

in 40-000065-2 release firmware there was no such a problem:

EXT3-fs (mmcblk0p2): using internal journal
Starting Bootlog daemon: bootlogd.
Populating dev cache
Configuring network interfaces... eth0: device MAC address 00:50:c2:11:22:33
udhcpc (v1.21.1) started
Sending discover...
libphy: stmmac-0:03 - Link is Up - 1000/Full
Sending discover...
Sending discover...
No lease, failing
SIOCADDRT: Network is unreachable
Starting rpcbind daemon...NET: Registered protocol family 10
IPv6: ADDRCONF(NETDEV_UP): usb0: link is not ready
done.
net.ipv4.conf.default.rp_filter = 1
net.ipv4.conf.all.rp_filter = 1

Please, write how could I fix it?


Replies (2)

RE: There is no eth0 device in 40-000065-4 release firmware - Added by Jeffrey Myers over 7 years ago

Anton,

I sent you an email with instructions on reconfiguring the camera.

RE: There is no eth0 device in 40-000065-4 release firmware - Added by Anton Bakulev over 7 years ago

Jeffrey,

Thank you. Yes, this instructions fixes the problem. Now my MityCam works well by eth0.

    (1-2/2)
    Go to top
    Add picture from clipboard (Maximum size: 1 GB)