Project

General

Profile

Activity

From 05/13/2011 to 06/11/2011

06/06/2011

10:35 AM Software Development: RE: Where can I get the files listed on the DSPLink Hello World wiki?
Hi Mads,
Most of the files you need are in the latest tarball release. I've sent you the remaining files, which wi...
Gregory Gluszek
07:14 AM Software Development: RE: Where can I get the files listed on the DSPLink Hello World wiki?
Hi
I am also looking for these files...
Could you email me them too?

Many thanks,
Mads
Mads Lind Christiansen

06/02/2011

12:17 PM Software Development: RE: ECC
Ok, Thanks for the quick response. Rob Gillis
12:11 PM Software Development: RE: ECC
We are using mobile DDR2 x16 for our modules. There is no support for ECC.
-Mike
Michael Williamson
11:56 AM Software Development: ECC
Hello,
Does the MityDSP L138 module support ECC for the DDR2 RAM? If so, is there software support to enable this...
Rob Gillis

05/27/2011

10:00 AM FPGA Development: RE: FPGA configuration
Rob,
The INIT_B pin (connected with external pullup to OMAP pin D2, AXR7/EPWMITZ[0]/GP1[15]) is an open drain outp...
Michael Williamson
09:37 AM FPGA Development: RE: FPGA configuration
Mike, I figured that readback may be an issue, but thanks for confirming it for me. Does the INIT pin provide proof ... Rob Gillis

05/26/2011

08:50 PM FPGA Development: RE: FPGA configuration
Hi Rob,
Right now, we don't have an easy way to verify configuration cooked up.
The current MityDSP-L138F famil...
Michael Williamson
05:32 PM FPGA Development: FPGA configuration
Hello,
I'm trying to figure out an approach for validating the bitfile has been programmed correctly, and for moni...
Rob Gillis

05/18/2011

10:46 AM Software Development: RE: uPP support
Hi Brian,
For the OMAP-L138, pin-muxing is just a fact of life. If you would like to use ethernet and uPP, then i...
Michael Williamson
09:32 AM Software Development: RE: uPP support
Hi Mike
This sounds good. An additional question would be about the pin configuration for the uPP port. In the exc...
Brian Rasmussen
08:02 AM Software Development: RE: Can't extract release 2011-03
Hi Mike
Thanks for your quick reply. I will try it out.
BR
Brian
Brian Rasmussen
07:53 AM Software Development: RE: Can't extract release 2011-03
Hi Brian,
The .run file is really just a shell script. Turns out that it is calling out "/bin/sh" to run the scri...
Michael Williamson
03:07 AM Software Development: Can't extract release 2011-03
Hi
I'm not able to extract the latest board support package release.
I have downloaded the "release_2011-03-31....
Brian Rasmussen

05/17/2011

10:53 AM Software Development: RE: uPP support
Brian,
You should not have a problem achieving the rates you mentioned above. We have accomplished similar throug...
Michael Williamson
10:44 AM Software Development: RE: uPP support
Hi Mike
We have discussed about the uPP port, and we have decided to try and use it in our project, due to the nic...
Brian Rasmussen
 

Also available in: Atom

Go to top
Add picture from clipboard (Maximum size: 1 GB)