Activity
From 06/15/2011 to 07/14/2011
06/30/2011
- 10:44 AM Software Development: RE: 1st time boot up
- Confirmed serial works - thanks.
06/29/2011
- 04:44 PM Software Development: RE: 1st time boot up
- Mark,
A new BSP has been posted. The serial port driver has been changed so that with a -M option, it will not ena... - 03:08 PM Software Development: RE: 1st time boot up
- Great, thanks.
FWIW I've verified USB and Ethernet works fine. I can comment out all the ports and run from the ser... - 03:04 PM Software Development: RE: 1st time boot up
- Mark,
It has been a little while and I wanted you to know that we have reproduced this problem and are working on ...
06/28/2011
- 12:25 PM Software Development: RE: OMAP I2C
- Rob,
The two utilities are convenient for easy command-line or script-based access to the I2C for simple control f... - Hello,
The MityDSP QNX BSP starts up the IC2 QNX driver, but also has two utilities (i2c_get, i2c_set) that bypass...
06/27/2011
- 01:58 PM Software Development: RE: 1st time boot up
- ...one more thing... Linux boots up fine, and reports:...
- 01:54 PM Software Development: RE: 1st time boot up
- I am currently running an unmodified boot script, the above section matches.
A log message immediately after
<p... - 12:02 PM Software Development: RE: 1st time boot up
- If you are seeing the Welcome banner, you should be through the start-up code and into the qnx kernel. By default, th...
- 11:45 AM Software Development: RE: 1st time boot up
- Wow - thanks for the fast reply.
I do want to use UART0, I was just trying that to see if it was the problem.
I a... - 11:35 AM Software Development: RE: 1st time boot up
- Mark,
Which board are you using?
Are both uart0 and uart1 available?
Is u-boot using uart0?
Did you change t... - I have followed the directions in the Wiki for booting up the MityDSP board, and I get as far as the banner before ev...
Also available in: Atom
Go to top