Activity
From 02/12/2014 to 03/13/2014
03/11/2014
- 01:01 PM Software Development: RE: Booting Linux
- If you would like to use the latest sd card image. Instructions can be found here: https://support.criticallink.com/r...
- 12:58 PM Software Development: RE: Booting Linux
- Excellent glad the guide helped.
Just so you know we updated the u-boot branch with timings for the DDR to run a... - 12:22 PM Software Development: RE: Booting Linux
- Successful boot of kernel 3.2 console messages. U-boot has been modified with new mii pin locations, so the kernel do...
- 12:14 PM Software Development: RE: Booting Linux
- Building the Kernel with your new instruction, version: mityarm v3.2, is booting correctly. I am using gcc-linaro-arm...
- 11:15 AM Software Development: RE: Booting Linux
- There shouldn't be any problem building the kernel with the SDK 06 version. Though I have not personally tested buil...
- 11:08 AM Software Development: RE: Booting Linux
- There aren't any changes in your .config file from the one in our AM335XPSP_04.06.00.02 branch.
- 11:06 AM Software Development: RE: Booting Linux
- Have you modified the kernel? If so were you able to boot using the unmodified version?
- 10:58 AM Software Development: RE: Booting Linux
- I have attached the .config file.
- I am trying to build the Kernel. After loading the Linux uImage file, I get the message:
"Uncompressing Linux... don...
02/20/2014
- 04:20 PM Software Development: RE: Booting from Nand
- Excellent this is a known issue. On boot the filesystem will try to calibrate the touch screen if its calibration fi...
- 03:27 PM Software Development: RE: Booting from Nand
- Hello again,
Thank you for your help so far; I have been making progress, but still stuck on the NAND boot. After ...
02/12/2014
- 04:51 PM Software Development: RE: Booting from Nand
- Looking at the diff I posted the alignment prints out in both cases. This is a normal boot printout.
From your ba... - 04:00 PM Software Development: RE: Booting from Nand
- Hey Jonathan,
I tried putting a few echo statement in some of the /etc/init.d scripts, but no luck. The boot is st...
Also available in: Atom
Go to top