Project

General

Profile

Activity

From 08/06/2015 to 09/04/2015

09/03/2015

11:55 AM Software Development: RE: Create ubifs
My mistake... misstyped MLO load addresses (0x4000 instead of 0x40000).
Started over an loaded everything from the...
Mary Frantz
10:03 AM Software Development: RE: Create ubifs
Mary Frantz wrote:
> So, of course, after reloading MLO and u-boot.img to get the console log....it boots from NAND....
Jonathan Cormier
09:58 AM Software Development: RE: Create ubifs
Ran the same commands on our board and was able to boot from nand. Note that I didn't boot from UART but this shouldn... Jonathan Cormier
09:48 AM Software Development: RE: Create ubifs
So, of course, after reloading MLO and u-boot.img to get the console log....it boots from NAND.
Mary Frantz
09:30 AM Software Development: RE: Create ubifs
See attached console log file.
Yes. I did the following:...
Mary Frantz
08:58 AM Software Development: RE: Create ubifs
Right, I forgot that they were inverted.
I'm not seeing anything wrong in what you posted, could you provide the c...
Jonathan Cormier
08:53 AM Software Development: RE: Create ubifs
From that page:... Mary Frantz

09/02/2015

02:15 PM Software Development: RE: Create ubifs
Try the boot cfg mentioned here: https://support.criticallink.com/redmine/projects/armc8-platforms/wiki/UBIFS_Nand_Bo... Jonathan Cormier
02:08 PM Software Development: RE: Create ubifs
I recompiled mtd-utils and made a ubi.img.
Also recompiled u-boot to get u-boot-spl.bin from u-boot-2013.10
Boo...
Mary Frantz

09/01/2015

02:01 PM Software Development: RE: Create ubifs
Here is a copy of instructions from the 1GB part. I'm going to copy it for the other parts as well.
*Note*: The "...
Jonathan Cormier
01:54 PM Software Development: RE: Create ubifs
I downloaded the base rfs from the Files tab. Ran the following:... Mary Frantz
12:17 PM Software Development: RE: Create ubifs
Hi Mary,
The exported root filesystem is the contents of the rootfs partition on your SD card. If you mount your S...
Bob Duke
12:01 PM Software Development: Create ubifs
I need to create a ubifs. Our product will not have a SD card interface, so first article booting will have to be ov... Mary Frantz
07:13 AM Software Development: RE: MityARM - ECC: uncorrectable
Thanks. This has fixed this problem. Angelos Spanos

08/31/2015

09:11 AM Software Development: RE: MityARM - ECC: uncorrectable
I tried to be as explicit as possible but the following error "Critical Link: Error u-boot compiled for large page na... Jonathan Cormier

08/28/2015

05:55 AM Software Development: RE: MityARM - ECC: uncorrectable
The bootlog is this:... Angelos Spanos

08/27/2015

01:20 PM Software Development: RE: MityARM - ECC: uncorrectable
Which module do you have?
What u-boot version are you using? Can you provide the bootlog from power on till you get ...
Jonathan Cormier
12:02 PM Software Development: MityARM - ECC: uncorrectable
Hi,
I have a MityARM card.
I try to flash the NAND memory according to the guidelines that are given for the Mi...
Angelos Spanos
 

Also available in: Atom

Go to top
Add picture from clipboard (Maximum size: 1 GB)