Mity CPU Platforms » MitySOM-5CSX Altera Cyclone V

05/26/2015

03:54 AM FPGA Development: HSMC1 pinout

Hi,
I am using the "mityarm_5csx_dev_board_hsmc_setup.tcl":https://support.criticallink.com/redmine/boards/47/topi... Florian Rieger

05/20/2015

08:22 AM Software Development: PHY not working with QSPI flash boot

Hi,
I am trying to set up the MitySOM such that U-Boot is stored on the flash memory and the Linux Kernel, DTS and... Alexandre Lopes

05/19/2015

03:30 AM Software Development: RE: Boot configuration jumpers

Thank you very much. As I've seen the labeling is to the right of the switch (in my case), hence I didn't pay attenti... Alexandre Lopes

05/18/2015

11:30 AM Software Development: RE: Boot configuration jumpers

Sorry this isn't clear. There is silkscreen labeling below the switch corresponding to the switch locations 1-10: MS... Adam Dziedzic

11:05 AM Software Development: Boot configuration jumpers

Hi,
Can someone please shed me some light on the boot configuration jumpers of the MitySOM-5CSX Dev-Kit? On the da... Alexandre Lopes

04/30/2015

07:53 AM Software Development: RE: Bare-metal interrupt handling working only in debugger

Hi Alex,
Glad you solved your issue, sorry we didn't provide much help. We don't have a lot of folks trying to do... Michael Williamson

06:22 AM Software Development: RE: Bare-metal interrupt handling working only in debugger

No, that was obviously not the reason. The unhosted and hosted linker scripts do link against different libraries but... Alexandre Lopes

04/28/2015

03:50 PM Software Development: RE: Bare-metal interrupt handling working only in debugger

I am now thinking that I might have to use the unhosted version of the linker script (even though it worked just fine... Alexandre Lopes

02:36 PM Software Development: RE: Bare-metal interrupt handling working only in debugger

Hi Mike,
That address is indeed the base of the interrupt table. I have been using it without any problem with oth... Alexandre Lopes

11:20 AM Software Development: RE: Bare-metal interrupt handling working only in debugger

I personally haven't tried to do this before, but isn't address 0x30000000 the base of your interrupt vector table? ... Michael Williamson

11:10 AM Software Development: Bare-metal interrupt handling working only in debugger

Hello,
I am using the MitySOM Dev Kit and I want to use interrupts in a bare-metal
application. To that effect I... Alexandre Lopes