Mity CPU Platforms » MitySOM-5CSX Altera Cyclone V

05/17/2021

07:08 PM Software Development: RE: Ethernet on MitySoM

Hi Jonas,
Looking at the device-tree binding doc for the phy it looks like if you specify the phy address you need... Daniel Vincelette

10:05 AM Software Development: RE: Ethernet on MitySoM

Hey Dan,
I checked the kernel configuration in menuconfig and directly in the .config of my kernel and the config ... Jonas Mair

05/13/2021

09:19 PM Software Development: RE: USB OTG - FTDI Device problems

Hi Dan,
Thanks for the feedback. That got it working!
Travis Rawson

05/12/2021

03:15 PM Software Development: RE: Ethernet on MitySoM

Hi Jonas,
You might not have the phy driver built into your kernel, so the phy skews aren't being set. I believe t... Daniel Vincelette

09:29 AM Software Development: RE: Ethernet on MitySoM

I apparently used the wrong gpio port, now the reset seems to be working correctly (ethtool shows a PHYAD of 3), but ... Jonas Mair

05/11/2021

12:01 PM Software Development: RE: Ethernet on MitySoM

Hey Dan,
thanks for the reply.
I created my dts with the sopc2dts tool, but appended the information given in y... Jonas Mair

05/07/2021

08:21 PM Software Development: RE: USB OTG - FTDI Device problems

Hi Travis,
I don't believe the reference project's kernel has built in support for FTDI serial devices. Looking th... Daniel Vincelette

07:54 PM Software Development: USB OTG - FTDI Device problems

Hello,
I am trying to connect a USB-to-RS232 dongle to the USB-OTG port on the MitySOM-5CSE-L2-3Y8 development kit... Travis Rawson

05/05/2021

05:59 PM Software Development: RE: Ethernet on MitySoM

Hi Jonas,
From looking at your boot log it looks like the kernel incorrectly found a PHY at address 31, where it s... Daniel Vincelette

05/04/2021

02:17 PM Software Development: Ethernet on MitySoM

Hello,
I have a MitySoM Module and the accompanying dev kit.
To use ssh and scp, i wanted to enable ethernet. For... Jonas Mair

04/30/2021

02:01 PM FPGA Development: RE: Using Signal Tap with the L2-3Y8 dev kit

Hi Travis,
I'm sorry for the long delay, are still seeing issues with SignalTap? My normal flow for SignalTap debu... Daniel Vincelette

04/19/2021

10:17 PM FPGA Development: Using Signal Tap with the L2-3Y8 dev kit

Hello,
I am trying to get Signal Tap working on the my system, but I keep running into failures. I am able to conn... Travis Rawson

04:08 PM FPGA Development: RE: Coldstart problem. Loading FPGA through Linux.

Hello,
I don't believe the RTC error message is related to the FPGA not programming. Can you post a boot log when ... Daniel Vincelette

03:09 PM FPGA Development: Coldstart problem. Loading FPGA through Linux.

Hello everyone,
we use the MitySOM module in our project. In works perfectly fine down to -40°C but only if the FP... Sergey Volkovoy