Mity CPU Platforms » MitySOM-5CSX Altera Cyclone V

05/21/2021

07:12 PM Software Development: RE: Ethernet on MitySoM

Hi Jonas,
The CSEL switches shouldn't have an effect on the ethernet interface, they are more used during the earl... Daniel Vincelette

04:27 PM Software Development: RE: Ethernet on MitySoM

I also tried it at home now (with your image) and I can reproduce the same behavior. So it points directly towards th... Jonas Mair

03:24 PM Software Development: RE: Ethernet on MitySoM

Hi Dan,
my plan was to take the board home over the weekend to test out a different router, in the office i test... Jonas Mair

02:37 PM Software Development: RE: Ethernet on MitySoM

Hi Jonas,
Thank you for providing the serial numbers. I've double checked our production logs and that development... Daniel Vincelette

08:41 AM Software Development: RE: Ethernet on MitySoM

Sure,
Baseboard: 1701 8998
SoM: 1803 5616
It's an 5CSX-H6-42A-RC Module
Regards
Jonas Jonas Mair

05/20/2021

07:57 PM Software Development: RE: Ethernet on MitySoM

Hi Jonas,
If you are also witnessing this issue with our stock SD card image then it sounds like there could be a ... Daniel Vincelette

04:59 PM Software Development: RE: Ethernet on MitySoM

Okay an update:
Skews are set correctly, I read them out with [[ https://github.com/wkz/phytool ]] and could confi... Jonas Mair

05/19/2021

05:23 PM Software Development: RE: Ethernet on MitySoM

Hey Dan,
I tried the device tree configurations you mentioned and also the generic ones adapted to my hardware from ... Jonas Mair

05/17/2021

07:08 PM Software Development: RE: Ethernet on MitySoM

Hi Jonas,
Looking at the device-tree binding doc for the phy it looks like if you specify the phy address you need... Daniel Vincelette

10:05 AM Software Development: RE: Ethernet on MitySoM

Hey Dan,
I checked the kernel configuration in menuconfig and directly in the .config of my kernel and the config ... Jonas Mair

05/13/2021

09:19 PM Software Development: RE: USB OTG - FTDI Device problems

Hi Dan,
Thanks for the feedback. That got it working!
Travis Rawson

05/12/2021

03:15 PM Software Development: RE: Ethernet on MitySoM

Hi Jonas,
You might not have the phy driver built into your kernel, so the phy skews aren't being set. I believe t... Daniel Vincelette

09:29 AM Software Development: RE: Ethernet on MitySoM

I apparently used the wrong gpio port, now the reset seems to be working correctly (ethtool shows a PHYAD of 3), but ... Jonas Mair

05/11/2021

12:01 PM Software Development: RE: Ethernet on MitySoM

Hey Dan,
thanks for the reply.
I created my dts with the sopc2dts tool, but appended the information given in y... Jonas Mair