Mity CPU Platforms » MitySOM-5CSX Altera Cyclone V

07/13/2023

03:11 PM Software Development: RE: Qemu pointers to try out mitysom-5csx Cyclone V Arm cortex a9 code

Hi Dan,
Thanks for the response. We do not have an actual hardware to do basic testing of the code. We are develop... Saumil Patel

07/12/2023

06:44 PM Software Development: RE: Qemu pointers to try out mitysom-5csx Cyclone V Arm cortex a9 code

Hi Saumil,
We do not have any experience using QEMU, our development is normally done on the actual hardware.
M... Daniel Vincelette

05:49 PM Software Development: Qemu pointers to try out mitysom-5csx Cyclone V Arm cortex a9 code

Hello,
Is there a wiki or any pointers to simulate using QEMU? I ran .\qemu-system-arm.exe -machine help and it li... Saumil Patel

07/07/2023

03:33 PM Software Development: How do I use ARM FVP or any other virtualization?

Hello,
Our application is MitySOM-5CSx based. We are trying to use FVP or QEMU for simulation during firmware deve... Saumil Patel

06/27/2023

06:13 PM Software Development: RE: Project files and Quartus startup

Eric,
https://www.intel.com/content/www/us/en/products/details/fpga/development-tools/quartus-prime/resource.html
... Mike Fiorenza

05:43 PM Software Development: RE: Project files and Quartus startup

Thanks Mike.
That page filled in a couple of knowledge gaps for me.
I'm still struggling to find out where to g... Eric Nelson

03:41 PM Software Development: RE: Project files and Quartus startup

Eric,
https://support.criticallink.com/redmine/projects/mityarm-5cs/wiki/Building_fpga_181
This should be the b... Mike Fiorenza

05:35 PM Software Development: RE: Pin-muxing SPI

Eric,
Thanks for sharing! I wasn't sure if it supported arbitrary GPIO pins or not. Good to know!
- Mike Mike Fiorenza

05:33 PM Software Development: RE: Pin-muxing SPI

Thanks Mike.
In case it's useful to someone else, I saw that the driver supports the use of "arbitrary GPIO pins":... Eric Nelson

03:36 PM Software Development: RE: Pin-muxing SPI

Hi Eric,
Your assumptions are correct. To use the hard HPS SPI peripheral, you would use the signals you have high... Mike Fiorenza

05:27 PM Software Development: RE: Toolchain bundles

Thanks Mike Eric Nelson

03:43 PM Software Development: RE: Toolchain bundles

Eric,
Use poky-glibc-x86_64-mitysom-image-base-cortexa9hf-neon-toolchain-2.4.4.sh which is under the Quartus 18.1 ... Mike Fiorenza

06/26/2023

09:51 PM Software Development: RE: Project files and Quartus startup

I'm also answering my first question (how to launch Quartus).
The executable name is quartus, and it seems that I ... Eric Nelson

04:01 PM Software Development: RE: Project files and Quartus startup

I found the answer to the second question on this page:
https://support.criticallink.com/redmine/projects/mityarm-... Eric Nelson

03:51 PM Software Development: Project files and Quartus startup

I'm just getting started with a MitySOM-5CSX and
First off, this page says "launch quartus", and I'm not sure how... Eric Nelson

03:53 PM Software Development: Toolchain bundles

There are three poky toolchain bundles on this page, and two of them have the same name, "poky-eglibc-x86_64-mitysom-... Eric Nelson