Activity
From 11/05/2024 to 12/04/2024
11/22/2024
- Fyi we recently discovered the flash script located here...
https://support.criticallink.com/gitweb/?p=meta-mityso...
11/21/2024
- 02:00 PM Software Development: RE: Request MTBF Data
- Hello Iseori,
We only have data for the 6254-TX-DAE-RI, which should be worse than the model you have.
At 25C, ... - Our customer is requesting MTBF.
Please supply the MTBF data for the 6252-TX-X8D-RI.
Thank you and best regards,
11/20/2024
- 08:23 PM Software Development: RE: meta-arago-extras/recipes-core/matrix removed
- Thanks Nathan. I have noticed that on the SDK 10 builds. TI recently removed the matrix-gui recipe so we just need ...
- 07:10 PM Software Development: RE: meta-arago-extras/recipes-core/matrix removed
- woops, that submitted early on me...
Anyway the warnings are...
WARNING: No recipes in default available for:
... - This causes some warnings b/c meta-mitysom still appends it...
11/19/2024
- 04:48 PM Software Development: RE: How to use the real time linux kernal
- TI maintains a separate -rt kernel branch, that has the realtime kernel patches applied. I should be able to apply t...
- 02:35 PM Software Development: RE: How to use the real time linux kernal
- Will we get this for free in SDK 10? I think it is kernel 6.6. I thought RT went mainline completely in 6.12? I am...
- 03:03 PM Software Development: RE: Ethernet 10Mbps Cannot ping
- Hi Iseori,
I double-checked your schematic's phy and magnetics parts, and nothing looked wrong.
Note that the ma...
11/15/2024
- 02:31 PM Software Development: RE: eMMC Linux boot failed
- The following commits were tested extensively on the 6.1 and 6.6 kernel. I can apply them on the 5.10 kernel however...
- 12:48 AM Software Development: RE: eMMC Linux boot failed
- Hi, Jonathan
Thank you for your prompt response.
We should be able to resolve this issue, currently at “Kernel:...
11/13/2024
- 02:48 PM Software Development: RE: eMMC Linux boot failed
- Jonathan Cormier wrote in message#6796:
> Hi Iseori,
>
> We have released an errata relating to emmc boot detecti... - 02:47 PM Software Development: RE: eMMC Linux boot failed
- Hi Iseori,
We have released an errata relating to emmc boot detection. See here: https://support.criticallink.com/... - Occurs on certain products, boots normally when product cools down.
Please review the below, attached and let us kno... - 02:33 PM Software Development: RE: Ethernet 10Mbps Cannot ping
- Hi Iseori,
I tested a 10Mbps link using our devkit and the KSZ9131RNXI PHY and had no issues. The PHY linked and ...
100/1000Mbps work well.
But, 10Mbps is only LINK and ping does not work. (both fixed 10M and auto-negotiation)
...- 11:17 AM Software Development: RE: USB Device mode communication problems
- Hello,
How is the USB0 device configured? As a gadget device (rndis, cdc, serial port, mass storage device, etc.)... - USB0 is set to device mode.
It stops working on some laptops.
The driver is detected but communication stops.
Th...
11/06/2024
- 10:56 PM Software Development: RE: How to use the real time linux kernal
- It likely wouldn't be hard for me to create one, I just don't have the time right now to test it.
- 09:46 PM Software Development: RE: How to use the real time linux kernal
- We currently don't have a kernel branch with the realtime kernel patches applied.
- I was wondering how we setup yocto to produce an image which uses the Linux real time kernel? Is there any documentat...
- 09:26 PM Software Development: RE: Recommended quick method to install Linux image on EMMC storage for high volume products
- Great glad it to hear it.
- 09:22 PM Software Development: RE: Recommended quick method to install Linux image on EMMC storage for high volume products
- Thank you, Jonathan. We were able to adapt the mitysom-auto-flash-emmc image and use it in our layer to flash the emm...
Also available in: Atom
Go to top
