Jonathan Cormier's activity
From 09/14/2017 to 10/13/2017
10/13/2017
- 05:18 PM MityDSP-L138 (ARM9 Based Platforms) Software Development: RE: TCF/TCI file questions
- Tom Riddle wrote:
> Hi,
>
> I'm on the DSP development learning curve and have been merging source from the dspli... - 01:26 PM MityDSP-L138 (ARM9 Based Platforms) Software Development: RE: Setting the ARM as a USB bulk device
- Note if you do break the unit you can reprogram it from scratch. [[Reprogramming_a_Dead_Board]]
- 01:09 PM MityDSP-L138 (ARM9 Based Platforms) Software Development: RE: Setting the ARM as a USB bulk device
- Okan Çalış wrote:
> The author of the blog "advises":http://blog.soutade.fr/post/2016/07/create-your-own-usb-gadget-...
10/11/2017
- 01:06 PM MityDSP-L138 (ARM9 Based Platforms) Software Development: RE: Setting the ARM as a USB bulk device
- Okan Çalış wrote:
> Hi,
>
> I downloaded the kernel and launched @menuconfig@, but as I expected, I got stuck in ...
10/10/2017
- 07:24 PM MityDSP-L138 (ARM9 Based Platforms) PCB Development: RE: MityDSP-L138F SPI Signal Access
- Yes, Good catch. Sorry about that.
Using a gpio pin for a chip select should work fine. Looks like there are 4 ... - 03:23 PM MityDSP-L138 (ARM9 Based Platforms) Software Development: RE: Setting the ARM as a USB bulk device
- Okan Çalış wrote:
> Thanks, but I'm already home. I'll download it from Git. The file is not too large.
Okay. No... - 02:27 PM MityDSP-L138 (ARM9 Based Platforms) Software Development: RE: Setting the ARM as a USB bulk device
- Okay well the bundle file is ~1GB. I can host that here somewhere for a few hours or if you have a somewhere I can u...
- 01:22 PM MityDSP-L138 (ARM9 Based Platforms) Software Development: RE: Setting the ARM as a USB bulk device
- Okan Çalış wrote:
> Hi, Jonathan,
>
> Thanks for your help. I've read Soutadé's blog (I had already read about RN...
10/09/2017
- 03:35 PM MityDSP-L138 (ARM9 Based Platforms) PCB Development: RE: MityDSP-L138F SPI Signal Access
- Tom Riddle wrote:
> Hi,
>
> I'm trying to figure out how best to gain access to one of the two SPI ports on the ... - 02:14 PM MityDSP-L138 (ARM9 Based Platforms) Software Development: RE: Setting the ARM as a USB bulk device
- Okan, Linux calls this a USB gadget. Depending on what peripheral you want to emulate you can enable different "gad...
Also available in: Atom
Go to top