Project

General

Profile

"JTAG Interface on MitydspL138F kit"

Added by Naveen K.S over 6 years ago

Hello sir,

In our development phase we are getting MitydspL138F Vision development kit, we are quite unsure with the JTAG interface. It was given in the VDK data sheet that to use XDS510 USB JTAG Emulator(14 pin) for dsp and FPGA JTAG cable.

But in MitydspL138F SOM datasheet it was told that "Both the JTAG interface signals for the FPGA and the JTAG and emulator signals for the OMAP-L138 processor have been brought out to a Hirose header that is intended for use with an available Critical Link breakout adapter.This adapter is not included with individual modules but is included with each Critical Link Development Kit that is ordered."

So kindly let us know whether that adapter comes with MitydspL138F Vision development kit we are purchasing, or tell us which JTAG (for dsp and fpga together or seperately) we need to get.

I am attaching the mitydsp vision development kit jtag details page for your reference. Kindly reply at earliest.

with regards,
Naveen K.S.


Replies (3)

RE: "JTAG Interface on MitydspL138F kit" - Added by Naveen K.S over 6 years ago

Hello sir,

Kindly reply to my query as soon as possible.

with regards,
Naveen K.S

RE: "JTAG Interface on MitydspL138F kit" - Added by Alexander Block over 6 years ago

Naveen,

The Critical Link debug adapter is included with the Vision Development Kit.

The following datasheet describes the included debug adapter: http://www.mitydsp.com/images/upload/File/80-000286_Debug_Adapter.pdf

The rest of the contents for the Vision Development Kit are outlined in the Quickstart guide which I have attached.

Please let us know if we can assist with anything else.

Alex

VisionDK_QuickStart.pdf - VDK Quickstart Guide (1.05 MB)

RE: "JTAG Interface on MitydspL138F kit" - Added by Naveen K.S over 6 years ago

Dear sir,

Thank you for your reply, it helped us a lot.

with regards,
Naveen K.S

    (1-3/3)
    Add picture from clipboard (Maximum size: 500 MB)