RS-485 failure to operate

Added by Mark Lyon over 12 years ago

Using a MityDSP L178 with industrial IO board 80-000268RI-2
Trying to use RS-485 via J504 - there are no signs of life on any of the pins - even tried manipulating the GPIOs directly. Any ideas?
Note: We were able to toggle other GPIO lines that come out the connectors on the back.

Replies (1)

RE: RS-485 failure to operate - Added by Gregory Gluszek over 12 years ago

Hi Mark,

My initial inclination would be to make sure that the pinmux is set correctly. Section 11.5.10 in the OMAP-L138 Reference Guide has more details on this if you haven't already verified these settings.

Are you trying to communicate through these pins on the DSP or the ARM?

\Greg

(1-1/1) Go to top

Project

General

Profile

Mity CPU Platforms » MityDSP-L138 (ARM9 Based Platforms)