Project

General

Profile

MityDSP-L138F Footprint Question

Added by Thomas Catalino almost 10 years ago

(posted on behalf of a customer)

For the MityDSP-l138F, I noticed the drill hole for the standoff in the Altium file (for the Industrial IO board) is acutally about 1780mils from the center of the DIMM Connector. As oppose to 2in - .2 shown in the diagram (in the carrier board design guide). Is the 20mil difference done to make sure that the L138F makes a good contact with the DIMM connector?


Replies (1)

RE: MityDSP-L138F Footprint Question - Added by Alexei Shkurko over 9 years ago

20mils is a mechanical tolerance for DDR2 connector placement

    (1-1/1)
    Go to top
    Add picture from clipboard (Maximum size: 600 MB)