Project

General

Profile

Activity

From 02/12/2011 to 03/13/2011

03/10/2011

02:17 PM Software Development: RE: How Do I Get SD Memory Working for Critical Link Carrier Board From Linux
David
the mount is done by udev. The scripts for udev are in /etc/udev/scripts
the file mount.sh is the one that mo...
Tim Iskander
02:12 PM Software Development: RE: How Do I Get SD Memory Working for Critical Link Carrier Board From Linux
Tim,
Thanks, remounting the drive in async mode drastically increased performance. I am now getting 4.3MB/s using...
david kasper

03/05/2011

10:21 AM Software Development: RE: How Do I Get SD Memory Working for Critical Link Carrier Board From Linux
Michael Williamson wrote:
> Hi David,
>
> TI has published performance numbers for their basic kernel (which our ...
Tim Iskander
10:14 AM Software Development: RE: How Do I Get SD Memory Working for Critical Link Carrier Board From Linux
Hi David,
TI has published performance numbers for their basic kernel (which our port essentially sits on top of) ...
Michael Williamson
10:05 AM Software Development: RE: How Do I Get SD Memory Working for Critical Link Carrier Board From Linux
Tom,
Thanks for your response. We would desire 4MB/s. Do you know how close to that number we could achieve?
...
david kasper
09:19 AM Software Development: RE: How Do I Get SD Memory Working for Critical Link Carrier Board From Linux
Hi David,
What throughput do you need or expect to get? I don't think the SD card is ever going to be as fast as ...
Thomas Catalino

03/04/2011

09:39 PM Software Development: RE: How Do I Get SD Memory Working for Critical Link Carrier Board From Linux
Mike,
The micro SD card is functioning with a FAT filesystem in our system. However, the write bandwith is slower...
david kasper

03/01/2011

08:25 AM FPGA Development: RE: FPGA example source
Hi Mike,
thanks for your response. I would like a simple gpio example for the fpga using the fpga_gpio.ko driver f...
Brian Rasmussen
07:28 AM FPGA Development: RE: FPGA example source
Hi Brian,
I can provide you with an example project if you are still stuck. Sorry for the delay. Please advise...
Michael Williamson
08:08 AM Software Development: RE: Include Path / Where is the correct source files?
Hi Mike
Thanks for your response. I am trying to access the EMIF from my application. I will prefer not to write a...
Brian Rasmussen
07:26 AM Software Development: RE: Include Path / Where is the correct source files?
Hi Brian,
Are you trying to write a driver or trying to access the EMIF via your application? Typically, direct m...
Michael Williamson

02/28/2011

09:18 AM Software Development: Include Path / Where is the correct source files?
Hi
I am trying to interface to the FPGA on a MityDSP-L138 board. I have succeeded building a new kernel, insertin...
Brian Rasmussen

02/26/2011

02:13 PM Software Development: RE: dsplink debugging issue
Hi Susan,
It looks like Richard raised this issue on the TI E2E site, here:
http://e2e.ti.com/support/developme...
Michael Williamson

02/25/2011

09:39 AM Software Development: RE: dsplink debugging issue
Was this issue ever resolved? I am running into the same problem.
Thanks,
Susan
Susan Begley

02/24/2011

03:33 PM FPGA Development: FPGA example source
Hi
I am trying to get the EMIF interface up and running between the uC and the FPGA on a OMAP-L138F Profibus Dev k...
Brian Rasmussen
 

Also available in: Atom

Go to top
Add picture from clipboard (Maximum size: 1 GB)