Project

General

Profile

Activity

From 02/08/2012 to 03/08/2012

03/06/2012

04:10 PM Software Development: RE: StarterWare question ...
Also, as a followup question, the StarterWare examples are setting up the system for the evmOMAPL138. For instance, ... Tim Eastham
02:56 PM Software Development: StarterWare question ...
(posted on behalf of a customer)
For the starterware non-os method, I have built some of the starterware examples ...
Thomas Catalino
10:16 AM Software Development: RE: Critical Link Package locations?
At the moment, we don't provide customized packages. The mityomapl138 location was generated during the bitbake buil... Michael Williamson
10:12 AM Software Development: Critical Link Package locations?
(posted on behalf of a customer)
What are the updated feed addresses for the critical link packages?

(these ar...
Thomas Catalino

03/04/2012

06:11 PM Software Development: RE: about boot
Mike,
Thank you very much. I understand.
shengyou gao
04:51 PM Software Development: RE: about boot
The EXT_BOOT# signal drives a small mux circuit on the SOM that changes the boot strap pull-up/pull-down options on t... Michael Williamson
04:56 PM PCB Development: RE: FPGA no-connects for 45 size FPGA on MityDSP-L138F
The bare board PCB for the two variants of the SOM are identical, the only difference is the BOM used for assembly. ... Michael Williamson

03/01/2012

08:28 AM Software Development: about boot
I wonder how the boot mode switch from SPI1 to UART1 using EXT_BOOT# signal? Thank very much. shengyou gao

02/28/2012

08:47 AM PCB Development: FPGA no-connects for 45 size FPGA on MityDSP-L138F
(Posted on behalf of a customer)
We have done a design using the MityDSP-L138F SOM. I tried avoiding using the pin...
Thomas Catalino

02/22/2012

05:01 PM Software Development: RE: Hello World Starter Guide Permission Issue
You rock! It was the file that was the problem. I found the executable and it worked. Thanks! Tim Eastham
04:50 PM Software Development: RE: Hello World Starter Guide Permission Issue
Hi Tim,
First, the reason you're getting the "-sh: ./hello.o: Permission denied" error is because the file you are...
Gregory Gluszek
04:25 PM Software Development: Hello World Starter Guide Permission Issue
I am a newbie to the arm environment and quite green on linux as well. I have been going through the hello world exa... Tim Eastham

02/16/2012

08:03 PM PCB Development: MityDSP-L138F Footprint Question
(posted on behalf of a customer)
For the MityDSP-l138F, I noticed the drill hole for the standoff in the Altium f...
Thomas Catalino
 

Also available in: Atom

Go to top
Add picture from clipboard (Maximum size: 1 GB)