Activity
From 12/27/2016 to 01/25/2017
01/23/2017
- JA 10:59 AM Software Development: RE: Programming the FPGA - Loading via CPU
- Hello, good day
I load the FPGA with "Example loading the .bin file over the serial port using Kermit" because it was easier but I will continue trying with TFTP server.
U-Boot > loadb 0xC0700000
## Ready for binary (kermit) ... - MW 06:58 AM Software Development: RE: SATA link down
- Are you using SATA-II or SATA-III link speeds? I believe the Errata from TI still applies.
01/22/2017
- FX 10:37 PM Software Development: RE: SATA link down
- hello ,I have the same problem !
Can you tell me this problem is Finish or not?
01/20/2017
- JC 01:51 PM Software Development: RE: Programming the FPGA - Loading via CPU - "ERROR LOADING"
- Jesus Alejandro Alvarez Trejo wrote:
> Hello, Good Day
> ...
Your ping command was run while booted into linux. You should run it while in u-boot to prove you have network communication working.
>
> ...
What tftp server are you usi... - JA 12:51 PM Software Development: RE: Programming the FPGA - Loading via CPU - "ERROR LOADING"
- Hello, Good Day
I am trying to load the FPGA using https://support.criticallink.com/redmine/projects/arm9-platforms/wiki/Programming_the_FPGA vía CPU, I already created the .bin file to do the first test. I am using the ...
01/12/2017
- JC 02:41 PM Software Development: RE: Programming the FPGA - Loading via CPU
- I don't understand the difference between this question and your last question. https://support.criticallink.com/redmine/boards/10/topics/5138
The programming guide from which you grabbed the above paragraph, includes the two ways tha... - Hi, Good Day, I am trying to load the FPGA via CPU, but I would like to know: How can I configure the slave select mode in the FPGA?. I read the Xilinx Spartan-6 configuration guide, but it is not enough clear.
"The FPGA has been con... - Hello, Good Day, I have the MitySOM-1810F PROFIBUS Development kit which includes the AM1810 ARM Microprocessor For PROFIBUS and Spartan 6, I would like to know how I can communicate both devices, I mean, what kind of protocol and how im...
- MW 11:08 AM Software Development: RE: Programming the FPGA
- Take a look at the [[Programming the FPGA]] for information about programming the FPGA. The wiki page on this web site has a bunch of information to get started.
If you want to program with JTAG via a Xilinx emulator pod, you can do ... - Hello, Good Day, I have the MitySOM-1810F PROFIBUS Development kit, I am starting to use it and I do not know how load the FPGA, I would like to know if I need a special connector or if I could use other method to load the FPGA.