Mity CPU Platforms » MitySOM-5CSX Altera Cyclone V

06/23/2016

04:47 PM PCB Development: RE: Development Kit 2.5V VIO, change to 3.0 or 3.3

Stephen,
Thanks for reaching out to us about this question.
Please note that making any modification to the car... Alexander Block

09:56 AM PCB Development: Development Kit 2.5V VIO, change to 3.0 or 3.3

It looks like banks 3B, 4A, and 8A have their I/O voltage tied to a 2.5V supply on the development kit.
If I want ... Stephen Snyder

12:32 PM Software Development: RE: Building BSP for 5cse

Hi Sam,
I'm currently re-running the yocto build here to see if I can recreate the issue you are seeing. I will up... Daniel Vincelette

11:36 AM Software Development: RE: Building BSP for 5cse

Hi Alex,
I selected the 5cse for the build, not the 5csx. I have done this full build no fewer than 3 times with ... Sam Anderson

11:17 AM Software Development: RE: Building BSP for 5cse

Sam,
I believe that the issue you ran into if following the Yocto wiki steps is that you may have selected the "mi... Alexander Block

06/22/2016

07:49 PM Software Development: Building BSP for 5cse

I am trying to follow your documentation for using Yocto to build an image for the 5CSE on the dev board carrier, and... Sam Anderson

06/21/2016

03:45 AM Software Development: RE: How to add aditional HPS GPIO's

Hi Alex,
Still a few misnumbered things in the above post.
Anyway, removing the switches from the DTS means tha... Matthew Schubert

06/20/2016

01:15 PM FPGA Development: RE: HDMI Output and Quartus Versions

Steve,
We have successfully rebuilt the "HDMI example":https://support.criticallink.com/redmine/projects/5csxbase/... Alexander Block

11:07 AM FPGA Development: HDMI Output and Quartus Versions

Hi,
I noticed that the HDMI Output example you've posted was done in Quartus 15.1 but the VM with the toolchain in... Stephen Snyder

01:10 PM Software Development: RE: How to add aditional HPS GPIO's

Maetthew,
Good catch. Apparently when I did the mapping I started off by one. We have updated the post above to ha... Alexander Block

02:09 AM Software Development: RE: How to add aditional HPS GPIO's

I have noticed that in the DTS the switches are now on the GPIOs that I want to use:
http://support.criticallink.com... Matthew Schubert

06/19/2016

11:26 PM Software Development: RE: How to add aditional HPS GPIO's

I'm having some issues setting GPIO37, 40 and 41 from within Linux.
Firstly, in the instructions above, you mentio... Matthew Schubert