Project

General

Profile

Activity

From 06/10/2017 to 07/09/2017

07/04/2017

03:13 PM Software Development: RE: Accessing NOR flash from Linux on 5CSX
We have a wiki page relating to using the quad spi NOR [primarily centered around booting from NOR]
(https://suppor...
Tim Iskander
08:10 AM Software Development: RE: Accessing NOR flash from Linux on 5CSX
Thanks Tim, that's good news.
Is there any specific doc. for the 5CSZ build? e.g. driver name, build instructio...
Bruce Kenny

07/03/2017

05:22 PM Software Development: RE: Accessing NOR flash from Linux on 5CSX
Bruce
Linux has excellent support for NOR flash devices using the mtd subsytem
http://www.linux-mtd.infradead.org/
...
Tim Iskander
04:53 PM Software Development: Accessing NOR flash from Linux on 5CSX
Our project is currently in the design phase and we are considering using a small amount of NOR flash to read and wri... Bruce Kenny

06/20/2017

05:59 PM FPGA Development: RE: Power fail interrup
Clyde,
Offhand our recommendation would be to utilize an HPS GPIO and have it configured in the GPIO controller as...
Alexander Block
05:14 PM FPGA Development: RE: Power fail interrupt
What more is there to say, really? We have a low voltage supervisor in our design and when the power is going to fai... Clyde Shappee
04:45 PM FPGA Development: RE: Power fail interrup
Hello Clyde,
Could you describe the situation a bit more?
Thanks!
Dan
Daniel Vincelette
02:05 PM FPGA Development: Power fail interrup
What is the recommended input to the SOM for a power fail interrupt?
clyde
Clyde Shappee

06/14/2017

09:10 PM PCB Development: VCCPGM and VCCBAT
Hello, I have a 5CSX-H6-4YA-RI board.
What do I pull the MSEL lines up to when I pull them up.
(what is VCCPGM p...
Craig Drennan
 

Also available in: Atom

Go to top
Add picture from clipboard (Maximum size: 1 GB)