Activity

From 06/12/2017 to 07/11/2017

05:51 PM FPGA Development: I2C Controller: Hello,
Unsure whether to post this under the software or FPGA topic.
We are transitioning from a mostly working... Harrison Barclay

03:13 PM Software Development: RE: Accessing NOR flash from Linux on 5CSX: We have a wiki page relating to using the quad spi NOR [primarily centered around booting from NOR]
(https://suppor... Tim Iskander
08:10 AM Software Development: RE: Accessing NOR flash from Linux on 5CSX: Thanks Tim, that's good news.
Is there any specific doc. for the 5CSZ build? e.g. driver name, build instructio... Bruce Kenny

05:22 PM Software Development: RE: Accessing NOR flash from Linux on 5CSX: Bruce
Linux has excellent support for NOR flash devices using the mtd subsytem
http://www.linux-mtd.infradead.org/
... Tim Iskander
04:53 PM Software Development: Accessing NOR flash from Linux on 5CSX: Our project is currently in the design phase and we are considering using a small amount of NOR flash to read and wri... Bruce Kenny

05:59 PM FPGA Development: RE: Power fail interrup: Clyde,
Offhand our recommendation would be to utilize an HPS GPIO and have it configured in the GPIO controller as... Alexander Block
05:14 PM FPGA Development: RE: Power fail interrupt: What more is there to say, really? We have a low voltage supervisor in our design and when the power is going to fai... Clyde Shappee
04:45 PM FPGA Development: RE: Power fail interrup: Hello Clyde,
Could you describe the situation a bit more?
Thanks!
Dan Daniel Vincelette
02:05 PM FPGA Development: Power fail interrup: What is the recommended input to the SOM for a power fail interrupt?
clyde Clyde Shappee

09:10 PM PCB Development: VCCPGM and VCCBAT: Hello, I have a 5CSX-H6-4YA-RI board.
What do I pull the MSEL lines up to when I pull them up.
(what is VCCPGM p... Craig Drennan

Also available in: Atom

Go to top

Mity CPU Platforms » MitySOM-5CSX Altera Cyclone V