MityCAM Vision Cameras

12/02/2016

07:53 AM Support: RE: Acquiring images from MityCam CIS1910 with exposures grater than 1 sec

Anton,
The dark calibration would have been cleared when you reflashed the SD card. For best performance, you shou... Jeffrey Myers

05:19 AM Support: RE: Acquiring images from MityCam CIS1910 with exposures grater than 1 sec

Update. It return non zero images only for exposures bigger than 6 sec.
With exposures in interval 6.01 - 6.1 sec im... Anton Bakulev

03:07 AM Support: RE: Acquiring images from MityCam CIS1910 with exposures grater than 1 sec

Jeffrey,
Thank you for your reply. I've upgraded a firmware successfully. Now it reports the following:... Anton Bakulev

03:01 AM Support: RE: There is no eth0 device in 40-000065-4 release firmware

Jeffrey,
Thank you. Yes, this instructions fixes the problem. Now my MityCam works well by eth0. Anton Bakulev

12/01/2016

07:56 AM Support: RE: There is no eth0 device in 40-000065-4 release firmware

Anton,
I sent you an email with instructions on reconfiguring the camera. Jeffrey Myers

04:44 AM Support: There is no eth0 device in 40-000065-4 release firmware

Hello,
I've installed a 40-000065-4 release firmware from [[https://support.criticallink.com/redmine/projects/mity... Anton Bakulev

11/29/2016

07:40 AM Support: RE: Acquiring images from MityCam CIS1910 with exposures grater than 1 sec

Thank you.
Yes, it's fully enclosed camera that was re-flashed several months ago in this post? [[https://support.cr... Anton Bakulev

07:29 AM Support: RE: Acquiring images from MityCam CIS1910 with exposures grater than 1 sec

Anton Bakulev wrote:
> I've tried to set clock rate to 40MHz but images acquired after that is zero valued. Did you ... Jeffrey Myers

05:42 AM Support: RE: Acquiring images from MityCam CIS1910 with exposures grater than 1 sec

I've tried to set clock rate to 40MHz but images acquired after that is zero valued. Did you tried this approach on y... Anton Bakulev