Activity
From 06/01/2017 to 06/30/2017
06/20/2017
- 05:59 PM FPGA Development: RE: Power fail interrup
- Clyde,
Offhand our recommendation would be to utilize an HPS GPIO and have it configured in the GPIO controller as... - 05:14 PM FPGA Development: RE: Power fail interrupt
- What more is there to say, really? We have a low voltage supervisor in our design and when the power is going to fai...
- 04:45 PM FPGA Development: RE: Power fail interrup
- Hello Clyde,
Could you describe the situation a bit more?
Thanks!
Dan - What is the recommended input to the SOM for a power fail interrupt?
clyde
06/14/2017
- Hello, I have a 5CSX-H6-4YA-RI board.
What do I pull the MSEL lines up to when I pull them up.
(what is VCCPGM p...
06/07/2017
- 02:20 PM Software Development: RE: Using EEPROM available on MitySOM-5CSX
- Hello Mike and Adam,
I very much appreciate you both providing other suggestions readily available with our MitySO...
06/02/2017
- 12:14 PM Software Development: RE: Using EEPROM available on MitySOM-5CSX
- The QSPI NOR is supported by the MTD layer, so you should be able to partition it and mount it using JFFS2 (or perhap...
- 12:05 PM Software Development: RE: Using EEPROM available on MitySOM-5CSX
- We're using the 5CSX-H6-4YA so we should have 32MB of QSPI NOR, and we are booting from SD card, though it's possible...
- 10:25 AM Software Development: RE: Using EEPROM available on MitySOM-5CSX
- Hi Jared,
If you are looking for a small amount of space, there is also some memory available in the RTC. There i...
06/01/2017
- 11:52 PM Software Development: RE: Using EEPROM available on MitySOM-5CSX
- Hi Jared,
Before you get into the I2C EEPROM, does the MitySOM you are using have the QSPI NOR FLASH installed (mo... - +Context:+
My team would like to store some non-volatile data specific to a unit of hardware (independent of the S...
Also available in: Atom
Go to top