Activity
From 11/15/2016 to 12/14/2016
12/14/2016
- 04:45 PM MitySOM-335x (ARM Cortex-A8 Based Products) Software Development: RE: KSZ9031 phy support for the 3.2 kernel
- Hi Everyone,
Merging in the changes from the tag (mitysom_AM335XPSP_04.06.00.07) worked for us to limit the ethern...
12/13/2016
- 01:15 PM MitySOM-335x (ARM Cortex-A8 Based Products) Software Development: RE: KSZ9031 phy support for the 3.2 kernel
- Looking at my JCI kernel branch it does show that it was before we added the micrel phy support. You mentioned we ga...
- 12:10 PM MitySOM-335x (ARM Cortex-A8 Based Products) Software Development: RE: KSZ9031 phy support for the 3.2 kernel
- I haven't tried you're suggestions yet. I will be able to this afternoon.
The kernel source we're using is much furt... - 10:57 AM MitySOM-335x (ARM Cortex-A8 Based Products) Software Development: RE: KSZ9031 phy support for the 3.2 kernel
- Note to confirm the Micrel phy driver is getting loaded....
- 10:54 AM MitySOM-335x (ARM Cortex-A8 Based Products) Software Development: RE: KSZ9031 phy support for the 3.2 kernel
- Timothy Entinger wrote:
> We are using a Critical Link BSP for the MitySOM using the AM335x and a baseboard that has... - 09:44 AM MitySOM-335x (ARM Cortex-A8 Based Products) Software Development: RE: KSZ9031 phy support for the 3.2 kernel
- I recently worked on this a bit.
Here are some u-boot patches to disable gigabit in u-boot. This won't affect linu...
We are using a Critical Link BSP for the MitySOM using the AM335x and a baseboard that has the Micrel KSZ9031 ether...- 10:22 AM MitySOM-5CSX Altera Cyclone V Software Development: RE: Preboot warnings and errors. uBootStatic.env and uBoot.env
- Dan,
Thanks for the info. Easy enough fix!!
Much Appreciated!
--Brian
- 09:33 AM MitySOM-5CSX Altera Cyclone V Software Development: RE: Preboot warnings and errors. uBootStatic.env and uBoot.env
- Brian
Those warnings are caused by the uboot environment trying to read external environment setup scripts from th... - Hello,
I am trying to figure out a couple of errors that occur during or right after pre-boot.
""preboot readi... - 09:05 AM MitySOM-5CSX Altera Cyclone V Software Development: RE: GPIO pins high during Pre-loader/Uboot 5CSE-H4-3YA
- Brian,
Glad to hear that worked!
Dan
- 08:56 AM MitySOM-5CSX Altera Cyclone V Software Development: RE: GPIO pins high during Pre-loader/Uboot 5CSE-H4-3YA
- Dan,
Thanks for the reply. I am able to better control them using an external weak pull down circuit on power up,...
11/29/2016
- 11:34 AM MityDSP-L138 (ARM9 Based Platforms) Software Development: RE: MityDSP boot problem
- Hi Greg,
Actually this was the page I referenced while I was working on u-boot. In the page, two solutions are sugge... - 10:15 AM MityDSP-L138 (ARM9 Based Platforms) Software Development: RE: MityDSP boot problem
- Hi Caner,
Have you looked at our wiki page ([[DSP_Quick_Start|DSP Programming Quick Start]]) for launching the DS... - 12:34 AM MityDSP-L138 (ARM9 Based Platforms) Software Development: RE: MityDSP boot problem
- Hi,
I followed the instructions in https://support.criticallink.com/redmine/projects/arm9-platforms/wiki/Das_U-Boot_...
11/28/2016
- 12:01 PM MityDSP-L138 (ARM9 Based Platforms) Software Development: RE: MityDSP boot problem
- It was my understanding that he was trying to build the UBL. In which case the source code is located at MDK_2014-01...
- 11:17 AM MityDSP-L138 (ARM9 Based Platforms) Software Development: RE: MityDSP boot problem
- Hi Caner,
Regarding U-Boot, the source code for the MityDSP-L138 U-Boot we use can be found on our support site in...
11/25/2016
- Hi,
We're working on a DSP software on MityDSP_OMAP-L138 board without BIOS and we do not intend to use ARM side in ... - 03:25 AM MitySOM-5CSX Altera Cyclone V Software Development: RE: Accessing git repositories when behind firewall
I found a good solution which might be worthwhile sharing :)
"How to Use the Git Protocol Through a HTTP CONNECT ...
Also available in: Atom
Go to top