Activity

From 06/13/2017 to 07/12/2017

12:06 PM MitySOM-5CSX Altera Cyclone V FPGA Development: RE: I2C Controller: Harrison
Whenever you change anything to do with HPS pin assignments, you will need to rebuild the preloader and upd... Tim Iskander

05:51 PM MitySOM-5CSX Altera Cyclone V FPGA Development: I2C Controller: Hello,
Unsure whether to post this under the software or FPGA topic.
We are transitioning from a mostly working... Harrison Barclay

03:13 PM MitySOM-5CSX Altera Cyclone V Software Development: RE: Accessing NOR flash from Linux on 5CSX: We have a wiki page relating to using the quad spi NOR [primarily centered around booting from NOR]
(https://suppor... Tim Iskander
08:10 AM MitySOM-5CSX Altera Cyclone V Software Development: RE: Accessing NOR flash from Linux on 5CSX: Thanks Tim, that's good news.
Is there any specific doc. for the 5CSZ build? e.g. driver name, build instructio... Bruce Kenny

07:36 PM MityDSP-L138 (ARM9 Based Platforms) PCB Development: RE: Analog input and outpur: Thank you for your answer Alex,
We will try to use Analog Expansion Kit provided by Critical Link.
btw do you h... Andri Haryono
05:22 PM MitySOM-5CSX Altera Cyclone V Software Development: RE: Accessing NOR flash from Linux on 5CSX: Bruce
Linux has excellent support for NOR flash devices using the mtd subsytem
http://www.linux-mtd.infradead.org/
... Tim Iskander
04:53 PM MitySOM-5CSX Altera Cyclone V Software Development: Accessing NOR flash from Linux on 5CSX: Our project is currently in the design phase and we are considering using a small amount of NOR flash to read and wri... Bruce Kenny

01:23 PM MityDSP-L138 (ARM9 Based Platforms) FPGA Development: FPGA coding and programming for customized board using Mity DSP L138F: We have made our own customized board using the Industrial IO board as well as the Analog Expansion board. We have th... Vivek Ponnani
01:19 PM MityDSP-L138 (ARM9 Based Platforms) Software Development: SPI interface for ADC5560 (MityDSP L138F): Hi,
I have a custom board with
1) MityDspl-138F module (with FPGA)
2) No Ethernet port
3) UART,USB,SD CARD int... Vivek Ponnani

05:22 PM MityDSP-L138 (ARM9 Based Platforms) Software Development: RE: To make the connection between DSP / ARM cores on MityDSP-L138: Our MDK provides an example utilizing TI's DSPLINK software to share data between the ARM and DSP cores of the OMAP-L... Alexander Block

12:47 PM MityDSP-L138 (ARM9 Based Platforms) Software Development: RE: data exchange: I've not really tried to send files over the terminal. But it should be possible using xmodem. The L138 filesystem ha... Jonathan Cormier
06:11 AM MityDSP-L138 (ARM9 Based Platforms) Software Development: data exchange: Help me please. How can I configure the data exchange with the Linux 3.2 kernel without using the Internet cable (com... Vasya Ivanov
05:58 AM MityDSP-L138 (ARM9 Based Platforms) Software Development: To make the connection between DSP / ARM cores on MityDSP-L138: Good day!To make the connection between DSP / ARM cores on MityDSP-L138, can we use your MDK with a previously develo... Vasya Ivanov

01:44 PM MityDSP-L138 (ARM9 Based Platforms) Software Development: RE: How to load Linux Kernel and files system with no Ethernet port: I'm not sure. Checkout this wiki from TI and let me know what you find out. http://processors.wiki.ti.com/index.php/D... Jonathan Cormier
01:27 PM MityDSP-L138 (ARM9 Based Platforms) Software Development: RE: How to load Linux Kernel and files system with no Ethernet port: Hi Jonathan,
Thanks for all your support. I am able to run helloWorld and testled programs on my custom board with... Vivek Ponnani

08:29 PM MitySOM-335x (ARM Cortex-A8 Based Products) Software Development: RE: suggested device tree: Note in the above uboot commands. We need to make sure that the bootargs variable is set correctly. In the previous ... Jonathan Cormier
05:59 PM MitySOM-5CSX Altera Cyclone V FPGA Development: RE: Power fail interrup: Clyde,
Offhand our recommendation would be to utilize an HPS GPIO and have it configured in the GPIO controller as... Alexander Block
05:14 PM MitySOM-5CSX Altera Cyclone V FPGA Development: RE: Power fail interrupt: What more is there to say, really? We have a low voltage supervisor in our design and when the power is going to fai... Clyde Shappee
04:45 PM MitySOM-5CSX Altera Cyclone V FPGA Development: RE: Power fail interrup: Hello Clyde,
Could you describe the situation a bit more?
Thanks!
Dan Daniel Vincelette
02:05 PM MitySOM-5CSX Altera Cyclone V FPGA Development: Power fail interrup: What is the recommended input to the SOM for a power fail interrupt?
clyde Clyde Shappee

08:04 PM MitySOM-335x (ARM Cortex-A8 Based Products) Software Development: RE: suggested device tree: Booted on a 3352 X4A using the attached files and the following commands:... Jonathan Cormier
06:59 PM MityDSP-L138 (ARM9 Based Platforms) PCB Development: RE: Analog input and outpur: Andri,
Thank you for your inquiry.
Our standard MitySOM-L138F development kit (http://www.criticallink.com/prod... Alexander Block

07:57 PM MityDSP-L138 (ARM9 Based Platforms) PCB Development: Analog input and outpur: Hello,
I own OMAP-L138F board and I am still new to this platform. Would you kindly inform me how can I set the bo... Andri Haryono

10:42 PM MitySOM-335x (ARM Cortex-A8 Based Products) Software Development: RE: suggested device tree: I've attached my dts which I created when I was playing around with the 4.1 kernel. Note that we really haven't test... Jonathan Cormier
10:32 PM MitySOM-335x (ARM Cortex-A8 Based Products) Software Development: RE: suggested device tree: Timothy Entinger wrote:
> > Did you get the 1GB DDR timings from our 2013.10 u-boot?
> Guilty!
Good. Just making ... Jonathan Cormier
08:57 PM MitySOM-335x (ARM Cortex-A8 Based Products) Software Development: RE: suggested device tree: > Did you get the 1GB DDR timings from our 2013.10 u-boot?
Guilty!
> Is there some reason you can't use our 2013... Timothy Entinger
08:12 PM MitySOM-335x (ARM Cortex-A8 Based Products) Software Development: RE: suggested device tree: Timothy Entinger wrote:
> Hello,
>
> We were using the 3352-HX-X38-RC part and we have that booting the 4.1 kerne... Jonathan Cormier
06:58 PM MitySOM-335x (ARM Cortex-A8 Based Products) Software Development: suggested device tree: Hello,
We were using the 3352-HX-X38-RC part and we have that booting the 4.1 kernel with device tree. We got a ba... Timothy Entinger

09:10 PM MitySOM-5CSX Altera Cyclone V PCB Development: VCCPGM and VCCBAT: Hello, I have a 5CSX-H6-4YA-RI board.
What do I pull the MSEL lines up to when I pull them up.
(what is VCCPGM p... Craig Drennan

Also available in: Atom

Go to top

Mity CPU Platforms