Activity
From 09/06/2014 to 10/05/2014
10/02/2014
- 12:53 PM FPGA Development: RE: HPS Memory Controller
- Hi,
 Just raising this subject again. I'm going through the document for the sgdma_dispatcher, but do you guys have...
10/01/2014
- 02:27 PM Software Development: RE: Port 22222
- Actually, the issue seems to be with the third party software.
 So don't worry about it.
- 02:07 PM Software Development: RE: Port 22222
- Furthermore, ssh works to it.
 We have a python program that tries to connect to the board via port 22222, but it r...
- 01:58 PM Software Development: RE: Port 22222
- Hi Bob,
 The only file I changed is the interface file in the /etc/network folder to give the system a static addre...
- 01:44 PM Software Development: RE: Port 22222
- Jack, I'm assuming you are running the "third party software" on the PC, correct?  
 If so, how did you configure t...
- Hi,
 We are trying to have a third party software to connect to the board via Port 22222. We assigned a static addr...
09/30/2014
- 12:41 PM Software Development: RE: Static IP Adderess
- Hi Dan,
 That works! Thank you!
 Jack
- 09:26 AM Software Development: RE: Static IP Adderess
- Hello Jack,
 Is your PC a windows machine? If so I believe if you have the firewall on then it will block any ping ...
09/29/2014
- Hi,
 I tried to set a static IP address to the system, by changing the /etc/network/interface file (See below). Bec...
09/17/2014
- 02:36 PM Software Development: RE: Standard USB peripheral connection on MitySOM eval Board
- Hi, 
 I'm now quite stuck without the ability to use use the host mode.
 I have noticed on Rocketboards something ...
- 11:29 AM FPGA Development: RE: Load FPGA Timeout Error
- Max,
 Thank you for posting that.
 You are correct that if VBAT is too low the module will either not boot at all...
- 10:41 AM FPGA Development: RE: Load FPGA Timeout Error
- Hi Dan,
 I had similar problem last week. After two week I tried to run my development board loading the FPGA with ...
09/11/2014
- 06:34 PM Software Development: RE: U-Boot with large uImage containing initramfs
- Hi Nicholas,
 A little confused. Your build_ramdisk_image.sh appears to be building a 1 GB image for loading an SD...
09/10/2014
- 04:03 PM Software Development: RE: U-Boot with large uImage containing initramfs
- Michael Williamson wrote:
 > We've run into this issue before on a different ARM based processor.
 >
 > The problem ...
Also available in: Atom
Go to top 
  
  