Project

General

Profile

MityDSP-Pro RGMII voltage

Added by Alexander Timokhin almost 9 years ago

Hello,

RGMII interface from TMS320C6455 DSP MAC can work with either 1.5V or 1.8V power suply.

What RGMII voltage is used on MityDSP-Pro boards (on Hirose expansion connector)?

Thanks,
Alexander


Replies (2)

RE: MityDSP-Pro RGMII voltage - Added by Michael Williamson almost 9 years ago

DVDD15 is connected to 1.5V.

VREFHSTL (for the EMAC RGMII) is set at to 1.5V / 2.

This is a provision to change the 1.5 voltage to 1.8 V, but it would require removal of 1 resistor (0 ohm jumper) and installation of a second on the board. This mode of operation has not been validated here, however, and you would either need to do the work at your factory or make arrangements for an alternate part number with our production team.

-Mike

RE: MityDSP-Pro RGMII voltage - Added by Alexander Timokhin almost 9 years ago

Thank you

    (1-2/2)
    Go to top
    Add picture from clipboard (Maximum size: 600 MB)