Project

General

Profile

Activity

From 12/10/2014 to 01/08/2015

01/08/2015

09:18 AM Software Development: RE: Simple Code/Doc for FPGA toggle of GPIO from DSP
Also, you should not be calling the destructor. This line is not OK:... Michael Williamson
08:29 AM Software Development: RE: Simple Code/Doc for FPGA toggle of GPIO from DSP
The driver could be rewritten to contain a shadow mask of the desired output register, but that is not the current im... Michael Williamson
08:28 AM Software Development: RE: Simple Code/Doc for FPGA toggle of GPIO from DSP
The code for the DSP GPIO control does a read modify write. It Reads the input state of the entire bank, masks the v... Michael Williamson
08:04 AM Software Development: RE: Simple Code/Doc for FPGA toggle of GPIO from DSP
Not sure what you mean with input ?,
both are mapped in the VHDL code as output. and set as output with SetPinDirect...
stefan nielsen
07:52 AM Software Development: RE: Simple Code/Doc for FPGA toggle of GPIO from DSP
Do you have the inputs of the GPIO core for offsets 0 and 1 connected in you FPGA design?
Michael Williamson
04:22 AM Software Development: RE: Simple Code/Doc for FPGA toggle of GPIO from DSP
Hi
If i want to toggle both pin 7 and pin 15 at the same time i have an issue (both work independently). Pin 7 goe...
stefan nielsen
08:29 AM Software Development: Interrupt source code for DSP
Hi All,
I try to figure out how to serve an interrupt in the DSP code and how to register an ISR for a FPGA interr...
Stefan Krassin

01/05/2015

07:08 PM FPGA Development: RE: Programming the FPGA
Hi
What was the solution to the last problem (add source error)? I get the same warning when trying to add pwm.ngc...
Flemming Abrahamsen

12/23/2014

06:28 AM Software Development: Simple Code/Doc for FPGA toggle of GPIO from DSP
Hi im trying to toggle a pin in the FPGA(busy/awake LED would do for now) from the DSP. Is there a doc(howto) describ... stefan nielsen

12/22/2014

06:27 AM Software Development: RE: DSP/BIOS issue MityDSP-L138
Thank Alex for your answer.
I think a problem was in incorrect PINMUX for UART-1.
My design works fine for UART-0...
Oleh Mela

12/18/2014

10:41 PM Software Development: RE: DSP/BIOS issue MityDSP-L138
Oleh,
Can you please share some more details about this issue if it is still occurring?
It looks to me like Ubo...
Alexander Block
 

Also available in: Atom

Go to top
Add picture from clipboard (Maximum size: 1 GB)