Mity CPU Platforms » MityDSP (TI TMS320C6xxx Based Products)

03/29/2012

05:25 PM Software Development: RE: emulator initialization from CCSV5.1

Also,
Have you double checked that the ribbon cable between the emulator adaptor board and the motherboard is not ... Michael Williamson

05:23 PM Software Development: RE: emulator initialization from CCSV5.1

Hi Peter,
Don't jump out the window! I will try to get some screenshots tomorrow for connecting via CCS5 and a SD... Michael Williamson

02:25 PM Software Development: RE: emulator initialization from CCSV5.1

A couple more screen shots (attached) that might be helpful.
I've tested my setup with a couple other TI C28 based... Peter Faill

11:50 AM Software Development: emulator initialization from CCSV5.1

I running Windows7.
I have the MDK-MB development board. I'm running CCSV5.1 and have a Spectrum Signal XDS510USB... Peter Faill

01:06 PM PCB Development: RE: Schematics for the MityDsp development kit motherboard?

Thank you,
Peter Peter Faill

12:47 PM PCB Development: RE: Schematics for the MityDsp development kit motherboard?

Hi Peter,
I just dropped in a schematic set for the MityDSP-6711 Development kit motherboard in the Files tab. Le... Michael Williamson

11:56 AM PCB Development: Schematics for the MityDsp development kit motherboard?

Where can they be found?
I see that the schematics are provided for the MityDSP-PRO dev kit under the forum's File... Peter Faill

03/21/2012

04:38 PM Software Development: RE: Loading code to on-board 6455 SRAM

It will copy from the flash to DDR2 then pass execution to DDR2. It is simple copy
which does not have the facilit... Dave Stehlik

04:30 PM Software Development: RE: Loading code to on-board 6455 SRAM

Mike,
how does the bootloader work? If my code stored in FLASH is linked such that part of should be located in L1 o... Bob Clarke

03/14/2012

10:13 AM Software Development: RE: Loading code to on-board 6455 SRAM

Hi.
At the moment, your observation is correct, the current bootloader does not support loading code directly to... Michael Williamson

09:41 AM Software Development: Loading code to on-board 6455 SRAM

(posted on behalf of a customer using MityDSP-Pro)
I have so far only loaded & run via CCSv5, but soon I will want... Thomas Catalino

09:40 AM Software Development: Placing code into onboard 6455 SRAM

(posted on behalf of a customer who is using the MityDSP-Pro)
I've been trying to put an interrupt service routine... Thomas Catalino