Project

General

Profile

Dual Bottom Side Connector Information

The MitySOM-A10S utilizes 2 connectors on the bottom of the module. The connectors are described below.

Note: The final board to board stack height of the connectors below is 10mm.

144 Pin Connector Details

Manufacturer Part Number Where Used Reference Designator
Hirose FX10A-144P-SV1 Module J600
Hirose FX10-144IP-8H(03) Interposer N/A
Hirose FX10A-144P-SV1 Baseboard J202

320 Pin Connector Details

Manufacturer Part Number Where Used Reference Designator Individual Stack Height
Samtec SEAM-40-03.5-S-08-2-A-K-TR Module J4 3.5mm
Samtec SEAF-40-06.5-L-08-1-A-K-TR Baseboard J201 6.5mm

Baseboard/Development Board to Module Standoff and Screws

Based on the above connectors the hardware used with our development boards is as follows

Component Quantity Manufacturer Part Number Height/Length Thread
Standoff 4 Lyn-Tron, Inc AA5083-3050-10.0-00 10mm Female M3x0.5
Screws 8 McMaster-Carr 92000A116 6mm Male M3x0.5

Please contact your Critical Link account representative for further assistance in confirming compatibility of any connector.

Go to top
Add picture from clipboard (Maximum size: 600 MB)